Recent content by R.Smith

  1. R

    V1505T injector pump adjustment screw? (update)

    Thank you. If I only knew exactly where stock was though. I'm fairly sure it's close though. Any ideas how it can be adjusted correctly?
  2. R

    V1505T injector pump adjustment screw? (update)

    Thank you for verifying that. After taking the injector pump out a couple days ago I was thinking "C" "might" be something like that. Please however maybe tell me how "smoke" plays into this. Too much fuel and it won't burn everything? I haven't touched that screw so maybe it's adjusted right.
  3. R

    V1505T Can Injector Pump Be Put Together Wrong?

    #5 is what I had put in 180 degrees. Very similar to the Zexel pump I have.
  4. R

    V1505T injector pump adjustment screw? (update)

    In another post I have ruger1980 said " Reference #5 shows the barrel and plunger assembly. I am not sure about the barrel but yes the plunger can be installed 180 degrees out. If this is done that injector will receive maximum fuel delivery and can cause the runaway condition. It also may not...
  5. R

    V1505T injector pump adjustment screw? (update)

    Thank you. I sure wish I'd asked about starting a fresh rebuild - being ready to shut off the air supply in case of a runaway is a great idea. I'll be ready next time.
  6. R

    V1505T Can Injector Pump Be Put Together Wrong?

    Thank you everyone who took the time to try to help. Ruger19 - you unfortunately have reinforced the idea that I need to take the injector apart again. But I thank you. I sure wish I'd been smart enough to ask about things "before" I started the engine. I'm crossing my fingers that damage...
  7. R

    V1505T Can Injector Pump Be Put Together Wrong?

    Maybe I said it wrong. Both the shut off solenoid deactivated with the switch and the shut off lever on the pump had no effect. I had to shut off the fuel at the tank. Pin 31. I don't even recall those but it's been several months. Not even sure some of the parts in the diagram are like...
  8. R

    V1505T Can Injector Pump Be Put Together Wrong?

    Help? Just wondering if I put the injection pump together wrong? There was one part and I don't know for sure if it was number 5 in the diagram or not but it could go one way or be rotated 180 degrees. I guessed thinking it might not make any difference. But maybe I made a bad guess and...
  9. R

    V1505T injector pump adjustment screw? (update)

    Could excess oil in the cylinders from the overhaul but causing trouble? Lots of white smoke on initial start. And excessive rpm and no shut off.
  10. R

    V1505T injector pump adjustment screw? (update)

    It was seized I assume because it had not been used in about twelve years. Just full of crude for a lack of a better word.
  11. R

    V1505T injector pump adjustment screw? (update)

    Thank you. If the repair manual for a similar pump is accurate I may have put the piston in 180 degrees from where it should have been. The manual says the engine would smoke badly and not shut off... which is what happens. But now I' not sure if the "piston" is the same as in my pump. I...
  12. R

    V1505T injector pump adjustment screw? (update)

    Greetings everyone. The injector pump was seized so I figured I needed to disassemble it. Unfortunately I had never done this before and I disturbed one of the screw settings. It's "C" in the photo I'll try to upload. When I started the engine after a rebuild it raced and wouldn't idle...