PoTreeBoy's latest activity
-
PHey just an update for everyone. I brought the Pistons and glands to my local, 2-hour drive each way, hydraulic dealer. They...
-
PPoTreeBoy reacted to racerboy's post in the thread Thinking about going from B2601 to L series with
Like.
my tractor finally arrived! It took a while for the air-ride seat to come in and they still didn’t have the rear remote, but at least... -
PPoTreeBoy replied to the thread Daily Chuckle.Me too, the 16' version. Same complaint, those thin rungs.
-
PPoTreeBoy replied to the thread L35 - BT900 Backhoe Swing Overhaul.Time to wrap this up. There are 12 hoses that run through the swing frame and I had to re-route them a couple of times before I was...
-
PPoTreeBoy replied to the thread L35 - BT900 Backhoe Swing Overhaul.I thought I referenced this post with hose dimensions, but now I see that I didn't. If you see any discrepancy in dimensions, please let...
-
PPoTreeBoy replied to the thread Need advice L3302 HST.There are a lot of unknowns here. But IF 1) it is genuinely out of warranty, and 2) it was still starting and running normally, I think...
-
PPoTreeBoy replied to the thread Need advice L3302 HST.I'll take a different approach. Since it still starts and runs, I'd fix the leaking hose. Then refill it with antifreeze solution, leave...
-
PPoTreeBoy replied to the thread must-have workshop features.Since you like hard board, consider 1/4" pegboard from 4' to 8' above floor level all around. Also, as previously mentioned, install...
-
-
PPoTreeBoy replied to the thread L35 - BT900 Separation and Derusting.The jaws and square part of the latch 050 appear to be zinc- chromate plated. The shaft of the latch is just zinc coated. I didn't...
-
PBack in 1988 or so, I had a 1983 Nissan Maxima diesel. A guy ran into me as he was making a left hand turn and messed up the hood...
-
PPoTreeBoy replied to the thread Seal Kits for BH75 backhoe.Sounds good. My hydraulic shop charges $100 each, and will usually do it in a couple of hours or less if I get there fairly early, since...
-
PPoTreeBoy replied to the thread Seal Kits for BH75 backhoe./Tweak on OK OP, two weeks is up. What have you done? Since you have the tools and the cylinders disassembled, I really don't see much...
-
PPoTreeBoy replied to the thread Need Advice (Desperately).My experience with buy back, admittedly different from OP's situation since it involved appearance only. My 10 yo SUV sustained hail...
-
PPoTreeBoy replied to the thread Front loader for a B7200.Just spit-balling here, but maybe the four-link arrangement bears consideration. You'd have to provide a support for the bottom pivot...
-
-
PPoTreeBoy replied to the thread Tank return hose diameter?.Did you get and install a PB adapter/plug in the valve?
