PoTreeBoy's latest activity
-
PPoTreeBoy replied to the thread Kubota L200 Rebuild.From your earlier post I was wondering how you'd get to the rod ends. Looks like that side panel behind the oil filter gives access for...
-
PPoTreeBoy replied to the thread L3400 1,200 Hrs - Transmission issues.I'd figure out just how low on fluid it is and fill it up. Low fluid could cause your problem.
-
PPoTreeBoy replied to the thread Grapple University.Two cylinders doesn't necessarily mean twin lids. Mine has a single lid with a cylinder at each end. It operates same as boom or dump...
-
PPoTreeBoy replied to the thread Bolt or bolt tip name and standard?.Here's what BS 4168 in the 23rd edition (1988) says. Sorry, this was before B18.3.6M, I believe. In any case, I think OP's is...
-
-
PPoTreeBoy replied to the thread Grapple University.The L35 loader capacity is ~1600#, I assume at the pins. The SGC1060 weighs 400#, so 1/4 of rated capacity. 1/4 of 952 is 238, the...
-
PPoTreeBoy replied to the thread What's cookin' boys?.You'd get strung up in Texas for calling that chili, but it sure looks delish to this southern boy.
-
PI think you got some solid advice from others above. I definitely agree that especially for smaller machine grapple can take a big bite...
-
PPoTreeBoy replied to the thread Grapple University.Hope this doesn't get too long. I started hauling the weed saplings I cut with the bucket (actually mostly on the arms above the...
-
PPoTreeBoy reacted to TheOldHokie's post in the thread L245Dt FEL front hydraulic pump and shaft problem with
Like.
My preference is chain couplers for the shaft and spin on wire mesh strainers with a bypass head for suction side use. Dan... -
PPoTreeBoy replied to the thread L3400 1,200 Hrs - Transmission issues.With HML, it must be hydrostatic - the manual is 4x2. OP, can you verify if it's hydrostatic? Can you shift it into high with the...
-
PPoTreeBoy replied to the thread L245Dt FEL front hydraulic pump and shaft problem.I'm pretty hard-headed, so I'd try to make the existing system work. After all, a similar system works on my L35. As @North Idaho...
-
PThank you for reading our story. Honor certainly comes in all shapes and sizes and colloquialisms carry different tones in different...
-
PPoTreeBoy replied to the thread L245Dt FEL front hydraulic pump and shaft problem.Can you turn the pump by hand?
-
PPoTreeBoy replied to the thread L35 mainshaft needed.@Fluke216 recently got some L35 loader parts from somebody in PA. I got the impression he was parting out the tractor. Try contacting Fluke.
-
PPoTreeBoy replied to the thread L245Dt FEL front hydraulic pump and shaft problem.It looks like it's not connected at the crankshaft, and I don't see splines on the crankshaft. Is that right? Here's a link to another...
-
