PoTreeBoy's latest activity
-
PPoTreeBoy replied to the thread Fuel shutoff activating prematurely, as key is released during startup.So you got it going? Was the transister bad? I forgot to mention that little box on the yellow wire from the transister is an unknown...
-
PPoTreeBoy replied to the thread Fuel shutoff activating prematurely, as key is released during startup.OK, so that may be an overspeed detector to trip the air damper. Probably also cut the fuel. Caveat: my limited experience. I once...
-
PPoTreeBoy replied to the thread I need help everyone..Take jumper cables with you.
-
PPoTreeBoy replied to the thread Fuel shutoff activating prematurely, as key is released during startup.Thanks for the schematic. Do you happen to have the control panel schematic? Your compressor has some shutdown features, oil pressure...
-
PPoTreeBoy replied to the thread B6000 clutch housing has broken open where it connects to the transmission.Don't forget to block the engine to the front axle, so it doesn't flop over, before you split it.
-
PPoTreeBoy replied to the thread Fuel shutoff activating prematurely, as key is released during startup.You may have a bad keyswitch. The black wire will be ground. As NIW said, one wire, red, will be hot always. Sounds like you have that...
-
PPoTreeBoy replied to the thread Engine Horse Power not as advertised.At 500 hrs you'd expect it to be just broke in, wouldn't you? How does it run? Could be something as simple as a dirty air filter. *...
-
PPoTreeBoy replied to the thread Daily Chuckle.Don't play dumb. Evvvrybody knows Debbie.
-
PPoTreeBoy replied to the thread BT600 Backhoe Control Valve Leaking.Don't all BX's have 1/4 inching?
-
PPoTreeBoy replied to the thread M9540 overfilled transmission.You might want to ask what oil the dealer used. Was it a complete change?
-
PPoTreeBoy replied to the thread L3010 Reverse only?!?!.If you're sure the linkage is working correctly, the problem is most likely the forward check/high pressure relief valve. There are test...
-
POk, following up on my tractor. I bought the tractor last Monday. I got my glow plug relay and time in and installed them. fixed my glow...
-
PPoTreeBoy replied to the thread Kubota b2150 HST not working.If you can't test the relief pressure, take it to the dealer and have them do it. The relief valve doesn't come out that way. That view...
-
PPoTreeBoy reacted to rgarraton's post in the thread BX23D with Starter Relay No Crank Issues with
Like.
I found it! It was the PTO Clutch Lever that was not making contact with the safety switch! -
PPoTreeBoy replied to the thread l3710 gst Starter stays engaged.In that case, I'd unplug it. You don't want to burn out the glow plugs, and it should be warm enough this time of year to start without...