Recent content by PEO

Thanks to all that responded. Wolfman and PoTreeBoy--You Nailed it-but I took the difficult route first. Because those that smelled the oil I took out and did not smell diesel and the transmission was a little low I took the more difficult route of replacing the hydraulic pump seal. The WSM...

In reading all of this, I think if i had a leaking injector, I would have a lot of black smoke on start up. As I put in my initial listing, I don't see any unusual exhaust. I always watch that for some reason. And the oil that I drained out does not appear to be overly diluted as i feel it...

Pulled my L3650 in after doing some grading and noticed new oil drips. Started checking and found the oil was way over full. Drained at least a quart of oil out to bring it down to the full mark. I know this can be serious fast... trying to get guidance on where to start... are their...

my L3650 has recently developed an oil leak that appears to be coming from where the lift arm comes out of the lift arm case. I have read through previous similar repairs to the lift arm piston, etc. My question is if this failure can be be repaired without removing the entire lift arm cover...

Problem solved.... drove to local Kubota dealer and got the parts.... Thanks guys...

GST transmission Loader cylinder seals let go with the onset of cold weather and were just replaced. With the loss of oil, I am going to replace the filters (2) before start up. Are generic filters available? The closest Kubota is miles away and need to get back in use. I just purchased...

Thanks all. I had a feeling that is what it was after getting responses. My older tractors did not have it. Found a great response on YouTube. I was used to draft control or selective draft / implement control. This makes adjusting to implement control only a little easier.

Has anyone done this repair. I recently purchased an L3650 that drips oil from appears from the top of the steering king pin on both sides. I don’t have my service manuals yet from the previous owner. Any suggestions.

I am a new owner of an L3650 and waiting on the manuals from the previous owner. I am trying to figure out the valve under the seat that reads OPEN — CLOSE. Any other tips appreciated.