Paul Allwood's latest activity
-
Paul, your drawing accurately reflects what I found. I'll see if I can determine the material thickness tomorrow. There are areas... -
Paul Allwood replied to the thread Front loader for a B7200.PS - I used to model things like this in Solidworks which takes out a good bit of the guesswork, but since struggling pretty bad with...
-
Paul Allwood replied to the thread Front loader for a B7200.I've just measured the range of motion for a LA344 (which is roughly what I'm copying) from screenshots from a video I found on YouTube...
-
-
Paul Allwood replied to the thread Front loader for a B7200.You're right, I will be building my own bucket, maybe a grapple, probably also light duty forks, don't know what else.
-
I think you're planning on building your own bucket so this would't matter, but if you're going to be using commercial attachments it...
-
I think those links could give a greater range of motion, but the TL720 loader specs on my L35 are +45° and -45°, less than Chim is...
-
Paul Allwood reacted to North Idaho Wolfman's post in the thread Front loader for a B7200 with
Like.
They also increase force. -
Paul Allwood replied to the thread Front loader for a B7200.Thanks Hugo. I did consider those extra linkages and even self leveling, but struggled to come up with something I was happy with for...
-
Now this is impressive angle information, thank you very much ! @Paul Allwood : I was always wondering what the purpose of those...
-
Paul Allwood replied to the thread Front loader for a B7200.If I understand your description, that gives a total range of motion between curl and dump of 150.5 degrees ? Another question - can...
-
-
Here is the information on my bucket. I'm guessing it is similar to most others. The tractor was parked on my bridge, one place that's...
-
The videos works for me now:) I'll check the range of motion on mine and get back to you. It appears yours currently moves slightly in...
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Chim
-
Paul Allwood replied to the thread Front loader for a B7200.I think I'm going to need to slightly adjust the location of the centre bracket holes for the end of the dump cylinder to slightly...
-
Paul Allwood replied to the thread Front loader for a B7200.Strewth - I think I've made it public. Does that work ?
