Paul Allwood's latest activity
-
Paul Allwood replied to the thread Front loader for a B7200.The beginnings of my SSQA....hopefully this should show a video. https://youtube.com/shorts/fzP8wWgT5no?feature=shared -
Paul Allwood replied to the thread Front loader for a B7200.Thanks, I'll try it.
-
Can't say that I've seen any directly-posted videos. A common method of sharing videos is to post them on YouTube and link them. I...
-
Paul Allwood replied to the thread Front loader for a B7200.I tried to convert a video to a GIF of the beginnings of the SSQA bits moving between curl and dump. The response to the first effort...
-
Paul Allwood replied to the thread Front loader for a B7200.1 step back, then a couple of steps forwards. The bush I had welded into the bottom end of the right side loader arm was out of line...
-
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks again Chim, the pics are very helpful.
-
Here are a few more pictures showing the engagement on the factory bucket The round pin measures 1-1/4"Ø (at least on my "Merican" tape...
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Chim - that makes sense
-
Comparing the round pin diameter to the dimensions of the slot can be a little deceiving. The pin (I can measure it but think its...
-
As TheOldHokie said, the drawing is minimal. The slot is 2" wide, so a 1-1/4 pin would give + or - 3/8" on engagement. My implements all...
-
Paul Allwood replied to the thread Front loader for a B7200.Thanks Dan
-
If it isnt spec'd it can vary. Notice that drawing is very minimal. Dan
-
Paul Allwood replied to the thread Front loader for a B7200.I've found a couple of references that suggest the wedge pin diameter is typically 1.25". Does this sound right, or since it's dimension...
-
Paul Allwood replied to the thread Front loader for a B7200.Excellent, thanks. I had found a version of this drawing but it was so blurry that I couldn't read any of it.
-
Here's the drawing from the official spec. SAE J2513. I think the slots for the pins has varied some in the past.
