Recent content by Orange1forme

I have used FluidFilm. End of the season I will paint whatever surface has been taken down to bare metal. As others have stated: wet heavy snow will clog it slow down observe your chute. usually one way is a more direct shot than the other, when possible use that direction if the snow quality...

I have swapped mine out and do not think there was much improvement. While operating the tractor, in my opinion, you have to have the volume up so high the stereo is about useless. I will say, with headphones on the stereo is almost good. You have to have the volume up pretty high. I have just...

I was able to find the same shear bolts at a local supply place(can't think of the name) that sells nuts, bolts, hydraulic hoses and similar. They sell them quite inexpensively as compared to Kubota.

I have black iron pipe on my front mount snow blower. I did try a single piece the length of the blower, but was unable to keep it straight or tight enough. I ended up just making it in sections. I did use bolts to secure it, but I do not remember exactly how I did it. I would have to go out...

For me the 5 gallon can are the way to go, although I am not a heavy use tractor person. They fit nicely into the Harbor Freight trailer hitch carrier to take and refill at the gas station. I used a battery operated transfer pump, from Amazon...

Front mount blower for me and gravel driveway about 3/4 mile long. I removed the "cutting" edge from the blower and replaced it with iron pipe pieces. I grooved the center enough to get it snug, drilled the existing holes in the pipe and bolted it on like the "cutting" edge. Almost no rock...

Something else that MIGHT be happening is if there is any grease in that spot it could be what is freezing. there is a plastic/HDPE/Nylon ring that the chute rotates on. Too much and/or the wrong grease will cause a binding issue and increase the freezing potential. Like others have said, clean...

https://www.colemanequip.com/search/b7304/ https://www.messicks.com/parts/B7304 https://www.messicks.com/parts/B7317

I was finally able to get in touch with the dealer and it was indeed the backhoe/pipe recall. Since I don't have a backhoe, and do not foresee it in my future, case closed.

I am the exact opposite. I would use this everyday, somehow. I am an a$$hole, though!!

Same here. Make me jump through too many screens or put in more info than is needed and I am onto the next site. The YT videos from Neal(sp) are useful, but I fully agree that their online shopping experience is HORRIBLE and shipping is just OUTRAGEOUS!!

I think the LX2610/3350 is the same engine as the B2650/3350. I did mine, B2650 cab model. The hardest part was getting the threaded plug loose. Once that was done it was very easy/simple. I may have watched that video and if it does not say, just get the heater ready to install(pipe...

I have the cab on my B2650. I put a fuse location next to the seat on the same surface/plane as the seat mount.

Compressed air or leaf blower or my 20V blower.

Very disappointing. NE WA. I WANT snow!!!!