Recent content by opalbeetle

  1. O

    B7200D Pilot bushing question

    So, I found where this seal is in the bell housing. If it's in decent condition, should I just leave it there? It looks to be in decent enough condition. I'm also wondering if there might need to be some serious voodoo science to get the new one installed into that spot.
  2. O

    B7200D Pilot bushing question

    Thanks for that information. Now, the release bearing holder has two oil seals that are pressed into the transmission end and I've replaced those, but there is a third seal that appears to slide over the holder. Does anyone know where this seal goes onto the holder?
  3. O

    B7200D Pilot bushing question

    Thanks, I actually found those part numbers this morning. I pulled the pilot bushing out, and it needs replacing for sure, but where does that oil seal go? Does it mount between the flywheel and the end of the crankshaft? I have looked for a picture of this but can't find a clear one, and I...
  4. O

    B7200D Pilot bushing question

    Thanks, sir! Interesting, I joined Orange Tractor Talks to get an answer from just up the road! Awesome!
  5. O

    B7200D Pilot bushing question

    Hello everyone! I'm new here and have been looking through the site for some time now. I recently purchased a 1987 B7200D and am thrilled to have a Kubota diesel! I have been learning how to understand the hydraulic system and recently the clutch/throw out bearing etc. Certainly a learning...