Recent content by OldSchool59

the pin could be easily pulled! The top tilt is working fine . I’ll dive back into it after I get out of my bow blind tomorrow morning and let y’all know what I find ! I really appreciate everyone’s help.

1 !

I’ll get on that first thing tomorrow morning! Thanks again

Thank you Sir! The shaft from the linkage has a collar on it attached with roll pins. I thought one of the pins may have sheared but the whole connected shaft is turning all of the way into the case. Something isn’t connected anymore on the inside. I could tear it all apart but it’s still under...

Dangit - not the draft but the 3pt lift ! I’m sorry

Something new and I don’t like it a bit . A couple of days ago I hauled my tractor to my other home place to do some work and when I got there the 3 pt would not lower . It’s all the way up and completely stuck . No- the speed adjustment is not shut off or locked off . The draft lever and...

And I thought I was a Cowboy :p

I’m in sandy soil and I’m having issues with dadgum gophers and pigs. I was going to build a drag (10’) out of I beam ( 5’ in front attached to a 10’ on the rear) but I’m hearing that a tandem split pipe should suit my needs better. I do treat ( kill ) gophers with my gopher plow but the last...

So just to let anyone else know , the L6060 Will lift a 2K lb pallet of corn or whatever easily, ! Yes , you have to have ballast and it’s Always important to keep the load as low as possible but it will do it safely ! There, the question has Finally been answered 😉

It’s been a while but this is the grapple I ended up purchasing!Yes, it is designed with double clamps and I definitely would not own a single after using this bad boy. Yes, it is designed to use the grapples in fully open position as a debris rake due to the stops . I have put this grapple...

I’m 225 myself - this seat is definitely going to bottom out and if you have back problems it isn’t going to be good! As far as grammar just go to their site, contact them and they will ask every question you need for fitment! Like I said, I purchased the darned thing, pulled my suspension seat...

these seats are rougher than my factory L6060 suspension seat ! I purchased one even after reading that on this site, installed it and it wasn’t good to say the least , I removed it after a half days use and went back to the factory suspension seat! These “air ride” seats will bottom out even if...

I built a shroud around minebut I do agree. Easier access vs open to easy damages!

We did but I have ADD lol!

Well Men, with a shortage of mechanics at our local bota dealer I don’t want to take it in there to possible sit for a month or two! It is under warranty and will be for 4.5 more years. If the valving is bad , it will show it’s ugly face so I will have to cross that bridge when I come to it! I...