Old Machinist's latest activity
-
Old Machinist reacted to carr5600's post in the thread Kubota Lx3310Cab Engine Warning Light with
Like.
It says serial no. It is displayed on the dash where the hours are. It goes from the hours to the code. -
Old Machinist replied to the thread Kubota Lx3310Cab Engine Warning Light.@carr5600 How did you obtain the P0089 code without a service tool? Seems like this would also fall under the 5 year emissions warranty...
-
Old Machinist replied to the thread Bill of Sale 1969 Ford 3000.I hear ya. My 99 would run circles around that old 69.
-
Old Machinist replied to the thread Bill of Sale 1969 Ford 3000.I bought my 69 Mustang fastback used with 20,000 miles on it for $2000.
-
I found the original bill of sale for a Ford we had that we sold a few years ago. It was kind of expensive for 1969 as you could buy a...
-
As followup: I checked refrigerant pressure, radiator and radiator screens and all seems good. I was finally able to search out the...
-
Old Machinist reacted to dano7200's post in the thread Vevor hydraulic steering unit for B series? with Like.
I find this steering power steering unit very interesting. It seems as though there is no actual pump on this? It creates 400lbs of...
-
Old Machinist replied to the thread techno geeks.I fell for a craigslist scam once advertising free fill dirt. They were collecting phone numbers to spoof. They spoofed my number and I...
-
Old Machinist reacted to chim's post in the thread Need help removing this part from bushhog with Like.
If you want to use a Dremel, I'd start with a real grinder and take material away so the broken part looks like an upper case D with the...
-
Old Machinist replied to the thread Hydraulic cylinder rebuild kits.Kubota shows a model B1630 loader for that model tractor. Your best bet is probably to call Messics or your local dealer. Look on the...
-
Old Machinist reacted to tootall81's post in the thread Need help removing this part from bushhog with Like.
Going with this. Soon as I put the parts puller on it, it broke the tool. Just gonna cut it off. Hopefully its not as bad getting a new...
-
Old Machinist reacted to Flintknapper's post in the thread Need help removing this part from bushhog with Like.
^^^^^ This would be my approach as well. The Splined shaft (tapered or not) is essentially 'welded' to the boss of the stump jumper via...
-
Old Machinist reacted to marrmanu's post in the thread Need help removing this part from bushhog with Like.
I just pulled the stump jumper on my RCR1248 due to leaking out put shaft seal. The shaft is tapered as mentioned. I heated it up real...
-
Old Machinist replied to the thread Need help removing this part from bushhog.After reading all the other suggestions and mine I would take this approach. Don't even mess with a puller or heat if you don't have...
-
Old Machinist reacted to Russell King's post in the thread Need help removing this part from bushhog with Like.
Not knowing the exact construction of your bush hog, I think you can now remove the gear box if that is in your plan. If that is not in...