Old Machinist's latest activity
-
Old Machinist replied to the thread Need help removing this part from bushhog.That is pretty obvious it's a splined hub on a splined shaft. It ain't gonna turn. You might be able to get a bearing puller on it. Heat... -
Old Machinist replied to the thread What did you do to or on your Kubota today?.Just another afternoon of mowing.
-
-
Been lurking around here since I bought my new L3902 last December and decided it was time to register. I'm no stranger to...
-
Old Machinist replied to the thread Biobor.Biobor JF DOES have instructions for contaminated tanks as well as a preventative treatment for clean tanks. Just read the labels and it...
-
Old Machinist replied to the thread Biobor.Doesn't sound like an either/or product. I have only used Biobor JF for the last 8 years and haven't had any fuel related issues so I...
-
Old Machinist replied to the thread Installing bung plugs in fuel tanks... any thoughts or insight?.When my fuel gets delivered and I add the Biobor JF I stick the nozzle into the filler and run it a while. That cycles the fuel through...
-
Old Machinist replied to the thread Installing bung plugs in fuel tanks... any thoughts or insight?.A large drain would be beneficial if it could be installed without risking the integrity of the tank. My New Holland backhoe has one...
-
Old Machinist replied to the thread What did you do to or on your Kubota today?.Years ago I built a ground powered mower I pulled behind my car to keep me out of the elements and dust. The very first time I used it...
-
I would second this. I have used this forum on and off for years for information for my old Cat track loader. Ten years ago I had a...
-
Old Machinist replied to the thread King Kutter finish mower bearings.Here is a kit on Amazon for $31. Doesn't show any wave washers but claims to be exact replacements and has 88 5 star ratings.
-
Old Machinist replied to the thread Forum for Kubota Excavators.Not Kubota specific but Heavy Equipment Forums has a excavator specific group. I frequent the backhoe group and it has lots of helpful...
-
Old Machinist replied to the thread Adding voltage gauge - questions.You should never have anything connected un switched. Since you connected it to the starter positive I suggest you remember to turn the...
-
Old Machinist replied to the thread Brittle Fender.I hate brittle plastic. My JD F725 has broken pieces all over. Doesn't do much good to repair it since it will just break in another...
-
Old Machinist replied to the thread Regen cycles on lx3310.My LX3310 just performed it's 6th regen in 110 hours. EDIT: I just realized my math was off because I shouldn't count the first regen...
-
Old Machinist replied to the thread Box or Grading Scraper?.I use my box blade most of the time. A landscape rake does a good job on gravel if you don't want to move a lot of material and just...
