Recent content by nota4re

  1. N

    Kubota L6060HSTC Stalling

    It is almost certainly a fuel issue. Electrical is a possibility - but far more likely to be fuel based on what you have provided thus far. I too think it may be icing/milky fuel. When you stall out, can you remove the fuel filter and see if fuel looks clear or if it looks cloudy/white? If...
  2. N

    UTV towing capacity?

    You might also want to look at the Pioneer 1000-4. Unlike virtually all other UTV's it actually has a transmission - not a CVT with a belt. In fact, the Pioneer's transmission is a dual-clutch transmission - essentially a manual but shifted by either you (via paddles) or by the computer where...
  3. N

    Buying a UTV

    Speaking of Honda... depending on your needs/use cases, you may also consider the Honda Pioneer 1000-4. It is an industry unique (yet very popular) SXS in a couple of ways. It has a pretty large utility bed in the back that does pivot/dump manually. However, it also has two seats that fold...
  4. N

    Paralysis by analysis - Buying decision needs wise input!

    I think lifting capacity is not to be underestimated/valued. Before owning and using a tractor, I thought about lifting capacity almost solely in terms of how much I would want to lift/carry and this thinking may not have placed enough importance on this specification. I'm in the process of...
  5. N

    Advice choosing between several different models…

    OP - I'm 6-2, 270lbs. I found it uncomfortable to sit on the L2501 and operate the treadle pedal - particularly when twisted around to look backward. My advice is to sit on all of the tractors you are considering and operate the pedals - both while looking forward and also when twisted around...
  6. N

    Do I need more horse power?

    If you're new to HST, this could also be a big part of the problem. It's kind of counter-intuitive. I recently did some work which required me to go up and down a steep concrete driveway. In the first attempt, I was in Mid-range and gave it the beans until it almost died about 1/3 of the way...
  7. N

    Hero to zero in six days

    2-pages of comments and no one seems to understand the simple concept and the root of all the angst. His crime of the century is not at all that he got Covid. His crime is that he lied stating that he had been vaccinated when, in fact, he was not. When people are believed to be vaccinated...
  8. N

    2021 l2501 w bh77 trade in?

    I was in a similar situation. I had my L2501 as my first small tractor but only kept it a year and about 60 hours before deciding I wanted something a little larger and with a cab. On trade, I got about 95% of what I had originally paid. Kubotas hold their value VERY well and I would think...
  9. N

    Solar Trickle Charger?

    OP - It's a great idea and will work well. I use one of these for each tractor as well as a dump trailer (which uses an automotive battery.) The link below is the kit that I have been using. Comes with EVERYTHING you need. Most importantly, it is a FLOAT charger so it will not over-charge...
  10. N

    I would make the 5-hour drive to go check them out and on the same day, also go sit-in and drive...

    I would make the 5-hour drive to go check them out and on the same day, also go sit-in and drive a Kubota. Which do you like better ergonomically? If I was you I'd be leaning toward the Kubota... but it might be enlightening to check out the Kioti. Again, in any case, I think you are going to...
    • nota4re
    • Profile post comment
  11. N

    I think you are going to have a lot of fun (and a lot of fun learning as well) regardless of...

    I think you are going to have a lot of fun (and a lot of fun learning as well) regardless of which you choose. I'm envious!! All things being equal, the Kubota seems like the good choice with a known-good dealer nearby. I guess the real question is IF all things are equal. Many Kubota...
    • nota4re
    • Profile post comment
  12. N

    Tractor runs fine, fuel gauge, etc. works. Dash warning lights do not. (L3650)

    Are the bulbs good? Did you check continuity across the filament with the bulb pulled out of the socket and again across the contact points with the bulb seated? Don't overlook the easy things!
  13. N

    Although at times embarrassing, I think the thread I started here has a lot of good info.... but...

    Although at times embarrassing, I think the thread I started here has a lot of good info.... but a few guys really getting mad at me. I would just encourage you to at least look at and compare price/features of the Kioti to the Kubota. This assumes there's a decent Kioti near you. If not...
    • nota4re
    • Profile post comment
  14. N

    Hi. The kubota fan-boys get mad when anyone suggests something non-Kubota but I would really...

    Hi. The kubota fan-boys get mad when anyone suggests something non-Kubota but I would really suggest that you consider a KIOTI DK4210SE Cab model. I recently upgraded from an L2501 and the difference is astounding - and I didn't break the bank! I really think (after a lot of my own research)...
    • nota4re
    • Profile post
  15. N

    Yup you guessed it--n00b could use advice on model/attachments

    With a normally aspirated engine the piston pulls down and draws air in through the intake valve. Then the intake valve closes and the piston pushes up and compresses the air. (I always picture a syringe with the plunger being drawn back.) In short, the more air you have in that volume, the...
See more
Top Bottom