Recent content by nicky

Quick update. First cylinder con rod bearing flattened. Second cylinder con rod bearing fine. First cylinder crank diameter is 42.75mm diameter. Thinking crank worn and bearing not tight fitting, started getting flattened when crank revolving. Connected back oil pump. Spun with drill . Had...

Yes. Found keymex. They had reconditioned pump. Will send to Ireland if needed. Thank for that.

Am turning the journals with fine emery paper. They were a little marked but nothing 15 hrs of polishing cant sort out.***128522;

I have gotten a pressure gauge to fit where the pressure switch came out. Putting in new bearings to keep pressure on crank and im going to turn the pump with a drill to see if i get a pressure reading from the pump. Should be around 60psi ???? Thanks for the info on the pump in Germany. Made...

Hi. Was in the process of getting a pressure gauge and putting it into the oil light port when it died. As the plug at the front of the cam is notorious for falling out , does the one at the rear fall out too ?? Im going checking the crank ports tonight to see if any are blocked. There must...

Hi. I have a b7000 that has ground up a new set of crankshaft bearings in 6 weeks to the point they are paper thin. Tractor wont run now. I thought it was the cam plug after coming out but it is not. I am in the process of cleaning oil ports to make sure crank ones are not blocked. Next step is...

hey vic. got account set up.will send cash when you ready !!!! nicky.

hi vic. want to do both con rods so will need 2 pairs. could you price a head gasket for it too and how much it would all cost to send to ireland and i will organise it thro paypal then. thanks a million vic, really got me out of a hole !!!!!! nicky.

hi vic. want to do both con rods so will need 2 pairs. could you price a head gasket for it too and how much it would all cost to send to ireland and i will organise it thro paypal then. thanks a million vic, really got me out of a hole !!!!!! nicky.

hi vic. we have a kubota b7000 that came to a dead stop a couple months ago and have found the reason being one of the bearings in the big end of the con rod is completely shot. while having it stripped down this much i might as well put new piston rings and gaskets back on while i...

ok. so i swapped around injectors. engine ran ok on cylinder two with either of the two injectors in it . after a bit of fiddling with the tappets on cylinder one i got it to fire but when it did it fired with a loud squeal of metal (only way i can describe it !!) so im wondering if it is the...

it was actually now you mention it. it almost always started on one cylinder and after a few seconds the other one would start firing but it was always very smoky when only firing on one. when i took out the two injectors cyl 1 was awash with diesel. i will swap around the injectors and see...

hi. was out tilling on tractor when it came to a dead stop . figured it was out of diesel so checked tank and it was half full. tried starting but sounded like battery was dead so stuck on new battery and still sounded dead. pulled decompression lever and away she went but as soon as...