Recent content by MrPeabody

  1. M

    L2800 shifting issue

    I have an L285 and had the same problem. I could be at a dead stop for several seconds, and it was nearly impossible to shift into any hear w/o grinding them. I adjusted the clutch with little effect. I had just purchased the L285 and had no idea what fluid was in the transmission or how long...
  2. M

    L285 runs cold

    Hi, Just wanted to post an update. I bought a IR thermometer as suggested (handy little device) and I can report that the engine is running around 180 degrees on a cool day not working too hard. So that seems normal to me. Therefore, the sensor most likely needs replacing. However, now that...
  3. M

    L285 runs cold

    Ok, thanks for the advice. Unfortunately I'm pretty much done using it for the season, but I will get an IR thermometer and check the actual temps next time I run it.
  4. M

    L285 runs cold

    Hi all, I bought an L285 a few years ago and I've been slowly working through some maintenance needs. It has always run cold according to the temp gauge. Recently I had the radiator boiled out, replaced some bad looking hoses, and replaced the thermostat while I was there. It runs the same...
  5. M

    Looking for 3 point hitch kit for my L285

    Hi All, When I bought my L285 a few years ago it had a Woods belly mower. I'm getting rid of that and converting to a 3 PT rear cutter. Now I need to buy a complete set of lift arms etc for the 3 PT. I have found hitch kits for B series tractors, but they don't have dimensions of all the...
  6. M

    L285 - How critical is Hyd fluid level ?

    Great idea, thanks so much !!
  7. M

    L285 - grinds gears on every shift

    Now that summer is here I'm resurrecting this old thread with another question about adjusting the clutch. I seem to remember seeing that the clutch pedal should be adjusted so that there is about 3/8" movement (can't remember where I saw that). As I adjust my clutch pedal it seems that the...
  8. M

    L285 - How critical is Hyd fluid level ?

    Hi all, Last year I bought a L285 and I've been sprucing it up as I find time. Recently I drained the gearbox and refilled it with some Universal Transmission/Hydraulic fluid from Walmart. My manual said the capacity was 7.3 gallons so I bought 7 gallons figuring all the old oil wouldn't...
  9. M

    L285 - grinds gears on every shift

    Sorry for the late reply, I got tied up with some other projects. I adjusted the clutch and things are much better now. Thanks so much for the advice !!
  10. M

    L285 - grinds gears on every shift

    Thanks, I'll take a look at the adjustment tomorrow. I should have thought of that myself, I guess I've been driving cars with hydraulic clutches for too Long... :)
  11. M

    L285 - grinds gears on every shift

    No, I didn't know about any adjustment. Thanks for the tip, I'll look into it.
  12. M

    L285 - grinds gears on every shift

    Hi Everybody, I bought an L285 a month or 2 ago and it is generally in good condition. The only thing about the tractor that bothers me is that the gears rake every time I shift. I always come to a complete stop, I slow the engine down to dead idle, make sure the clutch is pushed all the way...
  13. M

    New to me L285 - What Transmission Oil ?

    Hi Everybody, This is my first post here. I recently purchased a L285 which seems to be in fairly good condition. I am in the process of changing out fluids and doing other general upkeep. I have an owners manual and it clearly states to use 80W gear oil in the transmission. However, I've...