Mr Haney's latest activity
-
Mr Haney replied to the thread "New" Mower. Tell me How I Got Cheated.It appears the controller doesn't do anything good for the mower itself. The schematics show connections to the lawyer switches and... -
Mr Haney replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.Thanks for that help, Hugo. Based on all the written analysis I did yesterday, it looks like the controller's only purposes are to shut...
-
Mr Haney reacted to Russell King's post in the thread OEM Ignition Switch for ZD326 Worth the Extra $70+? with
Like.
@Mr Haney The PURPLE and RED in the marked schematic are close in color so be careful when looking at the screen to notice the... -
Mr Haney reacted to Hugo Habicht's post in the thread OEM Ignition Switch for ZD326 Worth the Extra $70+? with Like.
Here the wiring: red - 12V path for starter current to starter switch yellow - starter solenoid current path from start switch via...
-
Mr Haney replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.Thanks for the tip about voltage drop. I am posting a copy of the PDF page for the starting system. I am looking at it now and writing...
-
Mr Haney replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.Yeah, I went through all that in addition to repairing the ignition switch. Safety switches good. Relays don't appear to be the problem...
-
Mr Haney replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.There is not much to it. You open it up, and there are bunch of copper contact surfaces. Seems to me either they conduct or they don't.
-
Mr Haney replied to the thread "New" Mower. Tell me How I Got Cheated.I don't think the relay is the problem. I switched them around, and the mower still had no interest in starting. I also cleaned up the...
-
Mr Haney replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.You are probably right. I took the switch apart. It didn't seem worn, but there was a lot of oxidation on the contacts. I cleaned them...
-
Mr Haney posted the thread OEM Ignition Switch for ZD326 Worth the Extra $70+? in Service, Repair & Maintenance.I have been fiddling with my used ZD326, which refuses to start without hot-wiring. I thought I had a bad relay. Switching relays did...
-
Mr Haney replied to the thread "New" Mower. Tell me How I Got Cheated.Here is info that might be interesting for anyone who is cleaning up one of these machines. The armrest pads on this mower were in bad...
-
Mr Haney replied to the thread "New" Mower. Tell me How I Got Cheated.I found the seat switch wires down near the relay box. They had been twisted together and covered with duck tape, of all things. The...
-
Mr Haney replied to the thread Correct Way to Remove Cutting Height Dial from Zero-Turn.I took the shaft out and put it back in with no trouble at all. After removing the panel that covers the motion lever switch, there was...
-
Mr Haney replied to the thread Removing Old Grips from ZD326 Control Levers?.Coffee might help prevent posts like this.
-
Mr Haney replied to the thread "New" Mower. Tell me How I Got Cheated.In case anyone is wondering, the serial number on this mower is very hard to see when the deck is raised. I had a horrid time working...