Recent content by marrmanu

I kinda had the same issue with my 2620. In my case I but a new battery in, started ran then after sitting would not start, I jumped it and it started, then would not start. I re-tighten the battery connections and it starts and runs just fine now. Anytime I have a issue like this first...

I guess the bx 2370 and the bx 23s must be different, because all I had to do was tip the seat forward and start cutting, no removing anything!

Had same problem on my bx2370. There are a couple of videos on youtube that do the access port in the tank. I did not want to pull the tank as it looked to be a real PIA. So I did the port deal. It made accessing the tank easy, and I guess much easier than trying to access through the...

You will need to split, sorry to say. I got some tall grass twisted around the shaft of my 2620 which tore up the shaft seals. Does the 2620 have a BH? Mine has the BH and the BH mounting brackets according to the WSM they need to come off, however I was able to split the tractor without...

Thanks guys, yah 3ph, oops. I adjusted the feed back rod and it seems to be working ok. Thx again

My B2620 PTO shifter gets stuck on occasion. if it is all the was down or if all the way up, particularly if the lower arms have come up all the way to the BH mount. If it is "stuck" in either position I really have to force the hydraulic control lever it to get it to move, but once it is free...

No more bucking tractor! Before I replaced the brushes on the sweeper the sweeper would start jumping from side to side violently if it got above idle. It would sound like the whole thing was going to fly apart. I bought the tractor from my neighbors who used it on the road. When it got out...

Easier to get around stuff.

Thx No the bar will not clear :( I think you are referring to the wood on the grill. Its my chainsaw scabbard.

Just started using a little bit bigger brush hog this spring and noticed that on my properties hills I was losing traction. So I went to my Junk pile and came up with this.

Bx 42S

Not sure about the types. It is definitely not hydraulic. There are no rollers inside the chute. The fly wheel spins pulling the material up to 4" diameter in. In the past it would grab the material and pull it right in. Now it begins to pull for a few inches and then the material just...

I have a Bestco pinch and pull chipper that starts to pull material in but after chipping a few inches the material starts banging around and not pulling the material thru. I had recently changed the blades due to this issue which did not seem to help. The owners manual states that there...

Why do you want to take them out if the slope is that steep, do you have plans to do something on the slopes? In any case not knowing how deep the roots go and not familiar with the plant, I might try to wrap a chocker around and winch or pull them out.

My current shop is 25 by 50 , split in the middle. On half concrete floor for metal work and the other half for wood working. Wood side has a wood floor for running dust collection under as not to obstruct moving long boards ect. around the shop. Dust collection has pull cords at/near each...