Lumberjack1012's latest activity
-
Although those calculations are correct its based on the wrong info supplied. There is no way these LED lights draw that many watts... -
Lumberjack1012 replied to the thread BX22D priority valve.I answerd question on post #20 I will not post any further when the help is part of the problem its not worth it any more thanks
-
Lumberjack1012 replied to the thread BX22D priority valve.im not herer to argue with ya I had a qusetion I asked you didnt like the ansewer. The original question is this the releif valve and I...
-
Lumberjack1012 replied to the thread BX22D priority valve.relief valve was probably open because fluid was dead heading with the steer lines being reversed that is a fact
-
Lumberjack1012 replied to the thread BX22D priority valve.with all do respect why didnt you just say so if you knew the answer.
-
Lumberjack1012 replied to the thread BX22D priority valve.bad nylon or rubber orings inside spool replace them I dont know if they are in these but I have pulled many a spool in my time and...
-
I've finally had a go at using my new plasma cutter in a real project today - still trying to work out how to use it properly. It's a...
-
Lumberjack1012 replied to the thread BX22D priority valve.so when you told me to see if I had fluid on the presure side of the steering valve I just cracked the line and bumped key and I saw...
-
-
Lumberjack1012 replied to the thread BX22D priority valve.
-
Lumberjack1012 replied to the thread BX22D priority valve.flow rate is that what you are saying. The priority spool if it is stuck one way the fluit may not be getting to steering side. I bought...
-
Lumberjack1012 replied to the thread BX22D priority valve.not enough flow to make it steer correctly
-
Lumberjack1012 replied to the thread BX22D priority valve.im hooked up correctly pump may be bad. I got one coming. Still maybee the prioity valve. and yes fluid is at controller. All rubber...
-
Lumberjack1012 replied to the thread BX22D priority valve.dont have the right fitting for guage. I got this unit on the cheap and restored it trans/hydraulic tank was really dirty screen was...
-
-
Lumberjack1012 reacted to North Idaho Wolfman's post in the thread B6100E Electrical Issue with
Like.
Everything point to the Main switch being bad. You can confirm this really quickly with a meter or a test light on the switch terminals. -
Where I circled is that the priority valve spool my steering is hard to turn. I replaced seals in turn cylinder and that didnt help so...
-
