lugbolt's latest activity
-
Llugbolt replied to the thread Z421 belts.I have never taken the deck off to put a hst belt on those. The belt, yes but never the deck itself. the belt only goes one way, you...
-
Llugbolt replied to the thread Engine oil pushing out of crank case vent.check the oil level. If it's in between low and full, it's fine. what kind of oil is in it? are you positive that it's the correct...
-
Llugbolt replied to the thread Sidekick RTV-XG850 backfiring / loss of power.yes I'm aware. They build a lot of gas engines. There are gas "versions" of diesel engines (ZG332 for instance....). Cummins builds...
-
Llugbolt replied to the thread Fuel issue L3240.that works but there's an easy way to prevent air lock when changing fuel filter when you put the ring back on, don't tighten it. Turn...
-
Llugbolt replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.check the r/b wire. Do a voltage drop test between the key switch and the starter. If the drop is high, work your way back up the wire...
-
Llugbolt replied to the thread Sidekick RTV-XG850 backfiring / loss of power.subaru designed the KGZ770 (ZG222/227/ZG327) engine too. Also the RTV500. And Subaru built the entire RTV400 engine. Kubota builds...
-
Llugbolt replied to the thread Sidekick RTV-XG850 backfiring / loss of power.I'm curious as to why the compression is that low? What caused it? Wiped bottom end? Have you disassembled it to know if the bottom...
-
Llugbolt replied to the thread Lose bolts The bolts.there are a lot of different kinds of loctite. THey all have different numbers. 242, 271, 620, 680, etc new one one me, never heard...
-
Llugbolt replied to the thread ZD326 charging circuit problems..regulator failed.
-
Llugbolt replied to the thread Shuddering on left side of Z724 zero turn.that issue was originally addressed by putting a different tensioner spring on. I advised them that it wasn't the proper fix but...
-
Llugbolt replied to the thread Ram Ecodiesel Oil change question.not familiar with that engine but a lot of "older" engines that used cam-in-block, with roller lifters, the only thing that lubricates...
-
Llugbolt replied to the thread Z125SKH won't start.Brake switch failure will do exactly what you're describing. Every time! You can hear the solenoid clack but it doesn't really work...
-
Llugbolt replied to the thread Removing Cab from a Grand L 40.Don't forget to to check the vent. Transmission MUST be vented to atmosphere, if not, it'll build pressure and that pressure "helps"...
-
Llugbolt replied to the thread 48 inch Kubota Deck that know one can identify - RC48RTG.on a lot of the older kubota decks the lower seal was a completely different type of seal. I don't remember the dimensions or numbers...
-
Llugbolt replied to the thread Removing Cab from a Grand L 40.For anyone who might be reading...when I did kubota, lifting a cab was actually pretty easy with a forklift. It has to lift high...