Recent content by LRoyJetson

Sounds familiar

What a Flustercluk, glad to hear it was resolved. Sounds like Kubota and your dealer dropped the ball big time. Just curious, what unit are you going with now? Alot of machines (makes) now are similar, dealer support and service should always be taken into the equation.

This may be a better picture (Thanks jnschnit) Feedback rod (#030) was moving as directed by lift arm via (#040) Rod connects to feedback lever (#010) which rotates feedback shaft (#120). As shaft was frozen, lever only bent back and forth. Could see where paint was cracked on lever.

Mystery solved Lift arm (#1) connected to feedback rod (#2) was moving as designed. Feedback rod (#2) connected to feed feedback lever (#4) was moving as designed. Here's where it was tricky......... hard to see. Lever (#4) is connected to feedback shaft (#5.) Feedback rod was moving lever...

I moved it around some, didn't make a difference. Strange about the info., thanks for looking !

If I close the "speed control" valve, arms will raise but will not lower. (Rules lift piston out?)

The feedback rod attaches to the right side arm (as viewing tractor from rear) . Was thinking it was good and left was bent? Yes sir, I removed the snap rings for pics., as per whitetigers' post. Index marks look good, I can find ZERO info on adjustments. Thank you for your replies.

left arm looks bent to me. Since it is not attached to linkage, can that be cause? When lift arm are at max lift, there is no play in arms. Can not push up by hand any further, tight against something. Should arms be fairly easy to slide off shaft? These are not.

Yes sir, you are correct. I will get pics in the am. What is adjustment procedure for rod #30? When implement is raised to top position, I lose hydraulics to loader. Sounds like relief valve is in play. Small movement forward (lower), no noise and hydraulics return to FEL.

I have a 3 yr. old B2650 HSD w/ 130 hr. Have had zero problems so far. Noticed last time that I used finish mower (3 pt hitch mt), that mower wouldn't hold position. When lever is moved to raise the hitch, nothing happens until about no.8 on sticker. Hitch then raises all way to top. When moved...

I probably should have rephrased, By Kubota QA I meant their "pin on" system, vs. the SSQA. Sorry for the confusion.

I was just trying to figure out if the extra expense of the SSQA was worth it VS. the Kubota QA. Basically, what non-hyd. attachments were available. Some good suggestions here, thanks.

What attachments? (that do not involve hydraulics?)

There are very few products that are hard to find negative reviews on. The PTB is one of them, it does what it says it does, and is very reasonably priced. I really liked mine.(sold tractor, kept bar) don't know why. New tractor will have bigger bucket. (will order new PTB)