Recent content by LarryBud

Thanks for the post. I do have a blade in stock. I'd have to go out and purchase, and then store a plane. My attempt to use the blade in the past have not gone well. I admit that it's operator skill at the core and I will need to up my skill set to use it effectively. Or, just go out and...

After reading the label on this and other pre emergent herbicides, it looks like they are out. My drive slopes downward and I have trees I'd hate to lose living at the bottom of the hill. The runoff will likely be a problem. Looks like straight Glypho and mechanical solutions unless I can...

My gravel drive is growing grass and weeds at a disturbing rate. I spray it down with Glypho ( hand sprayer ) and as soon as I kill off a round of them the next batch comes through. The drive is fine other than the weeds. What must be done to clean up this mess? I have a rear blade and a...

Thanks to all who took the time to reply. I will be upgrading.

Good Call. Should be at spec. I may take them down some.

Does anyone have thoughts on an aftermarket. Suspension seat for my Gravely 52HD? It’s dry, the ground is hard and it’s killing me. Don’t want to throw money at it if it’s not going to change things much. thanks

Turns out they had a repair kit for this model. $15 and shipping. The original part was a molded plastic. I cut it off with a hacksaw. For now, all is good.

Thanks all. It’s a Woodford model K1C. They look to be one of the more common hydrants. I’ll look for parts and replace the whole thing if I must. I don’t have a backhoe so it’s with shovel work or a rental. I don’t like either.

Any way to just keep the pipe and put in new hardware back in the pipe without digging?

Hey Folks, I'm looking for some advice on my water hydrant. The handle on the head is old and starting to break ( one side broken ). It still functions for now but needs some muscle to lift and close. One of these days it will be broken all together and I'll have an emergency on my hands...

Lot's of good ideas shared. Thank you to all who replied. I think my first mistake was reading the Owners Manual.

I like it. Thanks.

Hey Folks, I have a 52" Gravely. Last time I changed the mower blades ( I have two sets ) with sharpened blades I removed the deck, flipped the deck up on the side and proceeded as described in the manual. Removing and reinstalling the deck, belts, springs is no small job on this model. It...

Thanks for all of the feedback. Couple of things I need to work on moving forward. One, is outdoor work space I can heat in any weather. This will likely be my house garage as insulating / heating the pole barn was would be a huge undertaking. Two, I need to upgrade my " Basement Hobbies...