Recent content by kubotaA17

Problem fixed. The parts arrived after 8 days a perfect job from Yenibiz. Fifteen minuts a little greas and it was installed. The part number in the manual is 66591-56320 and the replacement has number 66591-56315. Attached a picture of the residual and new part. It's amazing how much 4wd...

Universal joint assay (6C040-57542) has arrived and left the building. Splines and shaft diameters are the same. The bad news it's replaced by a much compacter assembly. Old one is 14.5 cm long and the new one only 9.5 cm. The only way to solve this is make it longer or a new shaft and the hole...

I'm ordering the part tomorrow. This will take a few days. It's dark again here in the Netherlands so clear pictures will follow later. Including old and new together. Thank you for you're support.

Thanks Ismurphy but I already have the pdf and that number see first post. Still unsure if the number of splines and shaftdiameter is the same. The fact that the arm of the parts is called a yoke helped a lot. Searched this forum on yoke and several people had the same problem. Ismurphy you...

For sure. If you show up at a dealer with the japanes partnumber they can't find the part. I think the part is the same on a B7500 or B2100. If sombody can measure the shaft diameter and count the number of teeth from the spline on one of these tractors I'm sure I order the right part. I think...

This is what's left. Spline is OK. The cross is gone probably plowed into the soil. I might be lucky there is a dealer for kubota parts in the next village. I can only get parts if I have a partnumber. The next stop will be at the japanes cardealer

Hello OrangeTractor people, Using a kubota A17 for 6 years . After discovering that is was a grey market unit I started to gather information. Bought a parts manual wich is very usefull. Getting the parts is not so easy. During plowing a big bang and stuck in the mud. After switching off the...