Recent content by KTinBisND

Totally understand that having a ball on the end of a pallet fork (or 2) is much easier to see. But I noted earlier that one of the things I will be moving is a camper with a likely 600 lb. tongue weight. Even with good ballast, seem like having that much weight on the end of 42" pallet forks...

All great advice. Finally went with 3/8" SSQA. Might experiment with longer 2" drawbar at some point (I mentioned I'd seen one at 20") to experiment with reach and better ability to place things. Always more stuff to play around with! You were all very helpful - Thank You!

All great info guys; thanks much. I will note that I have a hitch scale, so know the tongue weight of my camper with different loads. For towing, I keep it in the recommended range of 10-15% of overall load. It weighs 5,000 lb. or a bit more loaded, so a hitch weight of 600 or so is about right...

Looking for some advice on front mounted ball hitch for Kubota LX3310. I am parking quite a few items in a large cold storage building and need to be going forward so I can see and placing things pretty precisely. I see they make some simple ones that clamp to a bucket and also some that slide...

FYI, after all the good advice I went with 2.5" Bora spacers on the rear only. Thanks for all your help!

Really appreciate the advice, and the great pics. Have been comparing BORA and Bro-Tek a bit more. Looks like the price is nearly identical. I'm only seeing full inch increments from Bro-Tek; am I correct about that? Not sure 1/2" increments are a deciding factor; just want to make sure I'm...

Really appreciate your advice. I'm a math and science guy by training so tend to overthink all this stuff. Was out in the shop tonight and really looking at the rear wheel placement. As they come from the factory the rears on the LX3310 are very tight. So I got out my tape measure. The OD on...

Have an LX3310 with cab. Not working on real steep ground but always nice to have a little more stability, especially since the cab puts more weight up top. Leaning towards Bora aluminum spacers, but my main question is overall width. Thinking maybe 2 1/2" or 3" on each side? And should front...

Much hoopla about the new LX 20 series and they mention updated/improved seat and redesigned HST pedal. I have looked everywhere and can find no details about either of those descriptions. I am especially interested in what they've done with the HST pedal. Anyone know what these "improvements"...

Thanks everyone so far. The looking behind/neck issue would be the same for either. I've seen a couple of neat videos where they've mounted an RV camera to watch the rear action; very interesting. So a question to anyone who loves their Baumalight 1P24; why is it worth $1,200 more than the WG24?

Leaning towards buying a stump grinder for my B3200. Lots of looking at specs and videos; looks like either the Baumalight 1P24 or Woodland Mills WG24 are about the right size/type for what I need. looks like the WG24 is about $2,400, while the 1P24 is around $3,600. They seem so similar in...