Recent content by Killfast11

damn, wish i was closer

Your thread was a very good alternative to a fairly common problem.

True, I was referring to the power beyond on the steering unit

Thats k KIndah what I was thinking. This is a 2 wheel drive and I'm never gonna put a fel on it. So don't need a power beyond on it

That's the one I'm basically following.

The 5 port has an out and an aux port. The 4 port don't know if it's just an out or a combined out and aux

Basically gonna follow the one thread on here but have a few questions. My 8200 is a 2 wheel drive hst. I have no plans to put a fel on it as it's only 2 wheel drive. So doing this and using the valve block by the brakes, do I need a 5 port jd steering or can I use a 4 port one? If I use a...

i jdont think you have anything missing. just the lever is no longer lined up on the shift arm. your first picture. on the shift lever. there is a pin on the backside that goes into that slot your shift lever is hitting. i know because mine has come out a few times.

sorry those stamped metal frames make them a mower not a tractor

have any of you guys added these to your tractor and where did you mount the gauges at.

there is one i bought off of ebay that i was able to use. its not a direct bolt on as you have to make a new bracket since its thicker thatn the dynamo and it would set against the exhaust manifold. it cost 50 bucks and its internally regulated so got rid of the regulator. works really well...

Ill take it

mine idles at about 800rpm

An hst, yeah it ain't fitting there

Nothing added. If anything I have reduced the possible load by changing the headlights out to led