Recent content by ka24deroadster

I agree with you that you need to keep the ratio of the front tire to the rear tires correct. If you want to use the rolling circumference instead of the tire O.D. we can do that. The rolling circumference is probably a more accurate way to compare ratios compared to tire od. Going with the...

Well, first I am told that if I have 9.5-16 rear tires that I have to run smaller 5-10 fronts. Now I am told that I need to have a larger 5-14 front. Where is this information that everyone keeps giving out coming from? I know that just because something is a "Factory Spec" that does not mean...

I do notice the difference on the "Tractor Data" website. It is different than the data on the page from my factory Kubota owners manual. What information should i consider correct, the information supplied by my tractor manufacturer or the information supplied by a website? I would think that...

I logged into this forum to see if i could get a definitive answer to when and how you could run 9.5-16 tires on the back of a b7200, and now i am more confused than when i started. Where did you get the information that the front tire need to be 5-10 for the 9.5-16 rears? I have not seen the...

I have a 1630 FEL on my B7200D. I need to replace the hoses because they are falling apart. Does anyone have a list of lengths for the hoses? I could remove the hoses and measure them to get accurate length but i would like to only take things apart once. Are the fittings just standard 3/8" NPT...

My B7200 has a broken casting for the 3pt lower arm pivot. It was like this when I bought it so I do not know how it happened or how long it has been this way. I would like to do something to support the pivot before I break the other side. Has anyone done a similar repair? How did you do it? Do...

The new plugs physically are the same as the old plugs i removed from the engine. They are also the same voltage. I put them in and it appears that they work just fine. If you crank the engine over to get fuel in it and then hold the plugs on, the engine will move slightly from the fuel lighting...

That link is for "3 Glow Pugs Kubota Diesel B5200 B6200 B7001 B7100 B7200 B8200 D750 15951-65510" but Kubota has different numbers for the b7100 and b7200. The reason I asked what the difference was is because i have seen adds like this that show the same plug being able to be used for both, and...

Thank you for your reply. Part number 15951-65510 is the Kubota number. I was hoping that some one had a part number for another maker such as NGK.

I bought a B7200D that has been sitting for several years. I am trying to get it started but it just keeps turning over but not firing off. I drained the tank and put new diesel in it. I also bled the injectors. When i am cranking it there is white smoke coming out of the exhaust so I am...

I have a B7200d 4x4 tractor with a front end loader. I would like to add cylinders to the rear 3 point lift to be able to adjust the angle and tilt my scraper box. Where is the best place to connect the hydraulics to my control valve? Are there rear hydraulic ports for this? Do i have to connect...