Recent content by jsteinhauer

  1. J

    BX2822 fan shear bolt breaks repeatedly under load

    There is nothing wrong inside the gearbox. I regret opening it, or even taking if off the shaft. Do you know what it is sealed with? Gray silicone-like material. I should have inspected the main shaft bearing first. Images are below. It turns freely, but it has two dents in the housing. I...
  2. J

    BX2822 fan shear bolt breaks repeatedly under load

    It's a "locking collar," and it fastens on to the drive shaft with a Allen setscrew. Once removed, the shaft backs easy out of the bearing. It's a little strange, because the collar was behind the rear flange, and the parts diagram shows it right up against the bearing with the flange behind...
  3. J

    BX2822 fan shear bolt breaks repeatedly under load

    Finally getting around to this project. The gear oil is pretty dark and full of fine powdery metallic flecks, but nothing larger than a speck of dust, at least what exits the drain. I find one Youtube disassembling a BX2755, which is similar schematically to this one, and in that example, the...
  4. J

    BX2822 fan shear bolt breaks repeatedly under load

    My hands fit behind the fan. There is nothing back there. And the garage is heated. You can push the fan back about a centimeter when the bolt is sheared, it spins free as far back as it can go. It's fine for now. The loader is better for March snow most of the time, anyway.
  5. J

    BX2822 fan shear bolt breaks repeatedly under load

    I had the augers misoriented for a time, well before this occurred. They are correct now. And I wish I had seen @ken erickson 's post earlier. I have the blower off the tractor and the loader back on. I don't know when I will get time to open up the gearbox, but I will be sure to post back...
  6. J

    BX2822 fan shear bolt breaks repeatedly under load

    I don't think there is anything stuck behind the fan. It turns freely when the bolt is sheared. I'm more afraid it's a problem in the gearbox. Something broken or worn in there might still catch without a load then slip under load causing the thunk. I might just take the blower off and use...
  7. J

    BX2822 fan shear bolt breaks repeatedly under load

    I've been snowblowing with a BX2822 on a BX2380 for several years, and Saturday I broke the fan shear bolt for the first time on what looked like clean fluffy snow. Replaced it today, twice now. Purchased the bolts from the dealer. As the snow piles up a bit in front of the fan between the...