Recent content by jrsavoie

My wife has a LX2610 and I hate it for the most part. It does lurch. I don't like the foot control, I don't like getting on/off, on isn't as bad as off. The loader control is very jerky compared to what I'm used to. They seem to have fixed that. The machine is either too big for the...

How often do you grease your decks? We've always greased every 5 acres or so. This is the worst machine for greasing that we've had to in the past 45 years. I don't recommend anyone use the LX2610 with a MMM.

We're kind of partial to the older Toro front decks. It's what we've had and are comfortable with.

This is the worst deck I've ever been around. For greasing, removal, installation. Looks to be lighter duty than anything I've been around - 1980's John Deeres were much easier all around. Regretting selling our 1980 400. You'd think in 43 years Kubota would have done better

Thank you. What speed range do you run? I was running in M yesterday. High seems it might be a better choice.

Thanks. Glad I didn't get much done yesterday. Only 2 laps on a 2 acre patch. What gear do you mow in? I was mowing in M. Would H be better?

Where do I find the recommended Rpms in the book

Just tried using my MMM on the LX2610 for the first time. 2653 rpm is as high as it would go. What's the proper rpm for running the MMM? What should wide open throttle be? Any suggestions?

Just tried using my MMM on the LX2610. 2653 rpm is as high as it would go. Any suggestions?

How do you adjust deck cut height to 3" on the MMM? So far the MMM is our biggest regret on the LX2610. Way to complicated to remove and install for an old fat man. We got the MMM because I can't twist to see behind. I should have invested in another machine and /or mirrors &/or camera...

You're wrong

It's not

Is there a link to adjusting the deck cut to 3"? I thought I found something last year. We have yet to use the deck. If anyone wants a MMM for a LX2610. We might sell it. I don't have any find feelings for this machine. My wife likes it. It's hers, so that's all that counts.

Thanks not what I'm looking for. As of right now, my edge is still brand new. I was looking for a bolt on to augment it