Recent content by jonerik

i wired up a new alternator and diconnected the wire from the original permanent magnet dynamo, i remover the parts under the steeringwheel, wired up new cable, now i have good charging and great voltage, about the hydraulic valve, i opened it and see that the A-P-B isnt the correct marking...

i mounted an extra alternator, and wired it up with new cables, all works great and its no issue to use the electric winch in the front:)

yes have replaced all the wire. charge like heaven now:)

someone know what the switch at the left is for? when i use the right button, the pressure drops once i release it, i got 100bar at the output,

i tried with 2w and 4w bulb, no different, i checked all the cable, for me it was easier to just remove all cable and just mount a new DC-alternator, no i have correct charging and voltage is correct:)

after searching around about my problem, i have some thoughts, at idle, the dynamo/alternator doesnt charge at all, at det A-meter it shows that i use around 0.5A at full throttle is car reach up to 4A charging, i have replaced the chargelight with a led-light, but, thinking that maybe it has to...

can you move the tractor on the wheel? jack up the tractor ant se what happening when you tru drive with the wheels free

did you figure out this? i have a 1502 and searching how to get this work, art mune tractor i also got 50bar, any idea where the pressure regulator is located? and what is the maximum hydraulic pressure at his small tractor

i am also looking for this, also looking after manual, 1502 in mine

yesterday i checket the pressure at the electric, valve (the valve doesnt work ), when just using the starter-motor without to start the motor i got 100bar, that was testet at point "A". no oil are comming from "P" and "B" anyone have wiring diagram for this hydraulic system? from the dynomo it...

have read`n that, but not the same machine.

hi, just bought this tractor and i see that it needs some service and repair. i have some question that i hope someone here can answer me:) 1: PTO, i can`t move the handle to 3.gear, 1. and 2. is working but it be stuck after 2. gear. and if i use force it is hart to take it back to 2. again...