Recent content by jkcolo22

Nice looking welds! Did you not use the backer plate? I have a set of hooks and backers that have been sitting In my garage forever but my BXPanded have done just fine once I got them set up properly. What’s the US forest service for?

Check you linkages. Particularly at the joystick. My guess is that it’s a loose bolt rather than hydraulic. Sent from my iPhone using Tapatalk

That’s why implements are sized to HP... Too big an implement on too small a tractor... you can definitely break something. Sent from my iPhone using Tapatalk

2 is definitely too short. I run mine at 3.25. For me, anything less than 3 is a guaranteed scalp. Sent from my iPhone using Tapatalk

+1 for the piranha tooth bar. I have a Land Pride RTR0550 that I bought off craigslist, and I’ve been very happy with it. I wanted one from everythingattchments but the wait was more than I could handle. I do have a grapple and box blade from them, and they have served me well. When choosing a...

Be very careful... BHs are not designed to lift... Uneven ground and you can twist something badly. Sent from my iPhone using Tapatalk

I just installed and used my Pat’s Easy Change today. Made hooking up my tiller 100x easier. Sent from my iPhone using Tapatalk

Did you mean to say low range? High rpms, but low range gear will get me up just about anything. High range will bog down when the going get tough. My driveway has settled quite a bit, and sometimes I have to switch to low range just to get over the hump into my garage. Sent from my iPhone...

He said he’s using 5 gal cans to fill it... Sent from my iPhone using Tapatalk

Same here. Just be careful of any slope at all. Almost crapped my pants once... Sent from my iPhone using Tapatalk

What is your throttle at? Does it climb fine in low gear? What is your altitude? Sent from my iPhone using Tapatalk

Well you’re definitely doing better than me! Sent from my iPhone using Tapatalk

Dollies are a great suggestion. Just a couple inches “off square” can result in hours of frustration with heavier implements. Sent from my iPhone using Tapatalk

PTO driven implements are a PITA, but videos do help, and you do get better with practice. Well, at least until the end of the season, then it seems the learning curve starts over next year. Hooking up my tiller SUCKS. It’s heavy and getting the PTO shaft seated always gives me a hard time. I...

Clickbond products are made for exactly this application and far better than JB Weld. Sent from my iPhone using Tapatalk