Recent content by jimz49

Dan, thanks for all your help. I really appreciate it. Jim

One last question. The paperwork that came with the gauge said the correct pressure relief is 1778psi. Should I try for approximately that number, or should I set it at 1750 or 1800psi?

Okay. Thanks for clearing that up for me.

Is that the correct way to do it?

both off.

Well, I got it sorted. As luck would have it, the male fitting provided with the gauge fit the female connection on the back of my tractor that goes to the backhoe. I let the tractor warm up, ran it around the yard for a while and then checked the pressure. The reading was 1650psi at full...

Where did you connect the gauge? Was it at the middle line in your picture? How was the FEL used to run the test? Your question about the fitting prompted me to go look at my setup before I answered and I realized then that my fittings are different than yours. They're male fittings on the...

I know this is an older thread, but I have a question about where to connect the gauge on my 2003 BX2200. I recently purchased the gauge from BXpanded and received the gauge with a female fitting attached and a separate male fitting. I tried the male fitting in the center line shown in the...

No, I bought the sub-frame several years before finding the BT602. I was hoping to find a small Woods backhoe, but could never locate one. The BT602 showed up at a good price, so I bought it with the idea I would make it work somehow.

I also got the hoses from the backhoe sorted out. The folks at Messicks were great and got me straightened out. A big thanks to them.

I went back and looked at some of the paperwork that came with the sub-frame. As mentioned, I used a Woods 4-point sub-frame mounting kit for a BH6000 backhoe. The kit will fit Kubota's BX1800, BX1830, BX2200, and BX2230 tractors. The Model number of the sub-frame kit is 1008537. Hope that helps.

I bought a subframe for a woods backhoe that fit the bx2200. Had to mod the portion of the mount that bolts to the backhoe to work with the BT602

I have everything ready to go except identifying the hoses from the BT602. There are 3 hoses. I know one is in, one is return to power beyond (PB) and the last is return to tank. I have a setup where there is out from the tractor, return for power beyond and I'm dumping the return to tank...

I'm trying to figure how to attach my electric clutch driveshaft to the front pto of my B7100HST-D. As you can see in the attached pictures the front pto spline is larger than the driveshaft. Is there an adapter that goes in between? I know the electric clutch was used on a B7100, so it should fit.

Aquaforce, you da man. Bought a mid 60's vintage ford ac compressor clutch and it is exactly the same. Thank you so much!! Wondering if someone can help me out with another question. Looking at the front pto splined shaft (male), I measured the diameter as 1.16" or 29.5mm, and I counted the...