I'm trying to figure how to attach my electric clutch driveshaft to the front pto of my B7100HST-D. As you can see in the attached pictures the front pto spline is larger than the driveshaft. Is there an adapter that goes in between? I know the electric clutch was used on a B7100, so it should fit.
Problem Attaching Electric Clutch to front PTO
- Thread starter jimz49
- Start date
I don't know if it would be the same or not but my B 7100 had a hydrolic pump driven by the front drive. The pump had a sprocket attached as did the front drive shaft and were linked together by a double roller chain. I don't no if this will work for you or not.
Looks like you've already got an adapter on there that you don't need. If you look closely, you'll see there are smaller diameter splines on the front of the crank inside the ID of the adapter. I can see them in the pictures. It's slipped over the crank PTO spline and bolted in place (bolts are missing in the pics) to adapt to a larger spline. Pull it off (good luck!)and I bet your shaft will fit right on the spline hiding underneath
Last edited: