Recent content by HUNTnGA

Move the center link to the top hole.

Did you turn the key to the left and hold it till the glow plugs warmed up?

I bought mine new in 1992, addded an FEL in 2000. It has been abused in more ways than I can think of! Just ordered a BH attachment for it. The only drawback is no PW steering. As for the wheel wobble, make sure all of the linkages are good and tight, it doesn't take much. Also make sure...

BTW, mine is orange also.

Keep your fingers crossed, I just sent my deposit over to the Chi-Coms. I sure do hope that I'm getting what I'm paying for. A kubota BH would be nice but for less than 1/2 what they are asking for this one will do just fine.

My clutch won't return properly. It is very slow to come back up on it's own. I can pull it back up with my toes and then everything is fine. I have lubed every joint that I can find. Any suggestions?

You still got that BH?

I'm looking at buying an LW-6 backhoe attachment. Since my tractor (L2050) doesn't have rear remote hydraulics I was going to buy a PTO pump. However I got to loooking at my PTO shaft today and it just doesn't look like there is a whole lot of room there even with safety shield removed...

I just bought a used JD71 planter thinking that I could just bolt it to my cultivater frame. However it won't fit. I would post pics if I knew how. I'm new to this forum. Anybody got any ideas before I start cutting and welding this cultivater frame up.