hagrid's latest activity
-
Thank you! It took a little persuasion but worked with a punch and hammer and managed to get the bearing out along with the input shaft... -
Lift that axle off the ground, with a tire on it wiggle the tire top to bottom to check the bearings. Any movement or noise buy 2 new...
-
hagrid reacted to Paul Allwood's post in the thread Another Bucket Level Indicator Thread with
Like.
It's no for me. I wouldn't buy it - I would make it myself. -
I is a redneck.
-
hagrid replied to the thread Where am I leaking from?.Hard to determine the source. Purchase one can of Brākleen and apply liberally to the soiled surface. With any luck it won't take long...
-
hagrid reacted to NCL4701's post in the thread Promark 310 Wood Chipper Centrifugal Clutch with Like.
Centrifugal clutches are quite simple. https://youtube.com/shorts/-djNurMQfoc?is=umwkrDvPD3w37EkH. They work much like a drum brake...
-
hagrid replied to the thread Promark 310 Wood Chipper Centrifugal Clutch.Take a picture of the internals of this drum, plz. And clean out the rotor housing.
-
-
https://www.youtube.com/shorts/q_72FH7sr_w
-
Finally ran electric out to the pond.... No more stenchin cords... Whoppie :cool: 2 OSHA inspectors on the job... just in case I dug...
-
OK the little tractor is home, only 830 and change, still fuming about them putting new linkage rod in saying the one I took off was...
-
hagrid reacted to Runs With Scissors's post in the thread Front mount flail mower from mid PTO with Haha.
This is simply an "idea" (but not necessarily a good one ;) ) What if you made the attacch point such that the SSQA attached when it...
-
hagrid replied to the thread Air in oil. What is normal?.I think that is water; not air.
-
hagrid replied to the thread Telephone etiquette.Wet napkin.
-
An up date, call from the stealer 900 bucks,, not happy but what ya gona do,,, As long as it comes back and works for another 10 years I...
-
hagrid replied to the thread Telephone etiquette.pee-pees! lol
