Recent content by gunnerdog1

I am headed out of town from 11/02 until 11/17. We can hopefully connect when we get back! Thanks Dale

Will take any reasonable offer! Taking up to much room storing it! Thanks

Thanks everyone for your support! I will do some more troubleshooting later this evening!

Not sure on the 12 volts coming out of the switch! Have to figure out which terminals on back of switch are sending voltage out!

Hello! Yes did check the 30amp slow blow fuse and that was good! Even put a new one in for good measure!

Working on a bx2230 and got nothing when trying to start the tractor! Nothing lights up , no lights work ! Nothing! Checked battery voltage and have 12.77 volts! Got 12 volts to the back of the key switch! I do have an electrical schematic but can not trace out the issue for the life of me! Any...

Have a mower deck RC60-B off a B7200 with all mounting brackets for sale! Had a small rust spot welded over on one side off deck! Gear boxes and spindles are all good! Been using it right along! Been stored in my pole barn! Asking $400.00 for the complete setup!

I forgot to mention, the seat switch also has 4 wires!

Thanks for your reply! I checked all the switches with a meter, they seem to all be good! I guess I am stuck on the 4 wires at the brake switch, I currently have both sides of that switch connector jumpered, the only way I can get it to start! I did change out one of the 4 relays, ( one of the...

Hello Folks! Can anyone help out and help me locate a wiring schematic for a 2014 Kubota Z725KH zero turn mower? Having an issue with brake switch wiring I believe ! Removed the brake switch and jumped out the plug and mower starts and moves normally! But when you try to engage PTO switch ...

Thank you wolf man! I did get the seal out pretty easily! Popped right out! I am a little hesitant on trying to get the sleeve out , if I grab onto with pliers or something and it doesn’t move, than I would probably mark up where the seal rides!

Thank you! You guy’s awesome! I have it ripped apart! Is there a trick to getting the seal and sleeve out? I have a workshop manual I just got from a buddy but it doesn’t really show that! Thanks for everyone’s help!

Thanks for the response, I just got off the phone with messricks kubota parts and the parts person I spoke too wasn’t really able to come up with a part number: He said he was looking a different drawings and trying to piece them together but wasn’t 100 percent certain on correct part number...