GreensvilleJay's latest activity
-
GGreensvilleJay replied to the thread this site logs me off.....I'm using Firefox, settings are the same as before. clearing 'history' does NOT 'log' me off as I'm still here... might be a 'timed'...
-
G... past 2-3 days ,noticed that this site seems to automatically log me of, even though I've checked 'keep me logged in' box.... have...
-
GGreensvilleJay replied to the thread BT603 Cleanup Bucket Dimensions.A and B are the same , 3 3/4", maybe a tad smaller......
-
GGreensvilleJay replied to the thread Adding Draft Control to MX5400 with Rear Remotes.hmm....Kubota may say not to use it with 'float' valves , is that if the draft linkage is not adjusted properly, the implement could...
-
GGreensvilleJay replied to the thread L3902 HST - 3 point lift needs a small increase.how much does the seed weigh ? the drill's 1450# is probably close to the LIMIT the tractor can lift so adding 300# of seed more than...
-
GGreensvilleJay replied to the thread Non Functioning Draft.plow ! the dirt kind, to flip sod over and make neat ,tidy furrows...... blade !! to get a consistent level of material...
-
GGreensvilleJay replied to the thread Quieting your garage doors.After you install door insulation, be sure to retension the spring .
-
GGreensvilleJay replied to the thread BX ROPS question.ROPS is designed to only work when fully up and pinned, according to the warning labels. Also required to have seatbelt on. My seatbelt...
-
GGreensvilleJay replied to the thread BX ROPS question.I had E78 series Suburbanite snowtires on rears with 4 pcs of '4" billets' in the wheel wells...never got stuck in snow !
-
GGreensvilleJay replied to the thread BX2816 Snowblower Bare metal in the impeller housing.yes, could use a good quality urethane or epoxy.. I just have lost of thin SS laying about 'looking for a good home'.....
-
GGreensvilleJay replied to the thread BX2816 Snowblower Bare metal in the impeller housing.You could just 'adhere' a thin stainless steel 'band' to the blower..
-
GGreensvilleJay replied to the thread BX2816 Snowblower Bare metal in the impeller housing.thanks, hard to tell(old eyes....) A LOT of paint on it !!
-
GGreensvilleJay replied to the thread How This Simple Tractor Conquered the South Pole.I still prefer the Allis-Chalmers 'Snap-Coupler' system on my D-14s. Hands down far better.
-
GGreensvilleJay replied to the thread Easier way to take off/ put on ballast box.Kinda sounds like you're putting the top link on first and THEN the lower arms ? I've always done... right lower arm,PTO shaft( if...
-
GGreensvilleJay replied to the thread BX ROPS question.It's probably a 'legal/safety ' issue so can't sell just the top section.My BX23s wouldn't fit into the 7' 'normal' door height with the...