Recent content by GeoNLR

Thanks - Makes total sense. Especially reading the WSM on Backlash, clearances, and axial play max of 0.001" (factory 0.0008). I guess it's time tp bite the bullet! Who's going to tell the dealer they were right??? HAHA -Ouch-

Got out the WSM and did some digging ... I'm assuming the 'worm shaft' is what's bent... and hopefully it's part of the 'ball nut'? Looking at the 'Axial Play of Ball Nut Assembly, it would appear so! With an allowable limit of 0.001 inch... may be a gamble to try and just replace this part as...

Awesome - TY! Just to confirm - the TC220-37020 will include the bent shaft I attached a picture of above? I searched for the PN and found it ($1,059), but there are no pictures.. errrr!!! Thanks again - Geo

PLEASE! haha - I have moved the tractor to another shop and they said the input shaft is badly damaged. L3901D (3901 HST 4x4) SN 57929 Info off box - 120C11501 KOYO MADE IN JAPAN I'll owe you a beer or 12 if this works out.

Awesome - Thanks - Geo

Much appreciated!!!! Can you send me the link to the diagram you took a screen shot of? I'm looking through my WSM and having a problem finding it. Should I just order these (4) kits highlighted and take to another shop? Or would it be worth my time to try and DIY, take the pump off and...

I was using the tractor and lost steering. Noticed it was leaking fluid from the input shaft (?) on the right hand side of the tractor. Took it to the shop and they said Kubota didn't offer a rebuild kit on the power steering assembly (PN TC220-37005) and a new one (with new pitman arm PN...

Is there a number for Kubota where they could possibly answer the question? Thanks for the help - Geo

By the way... I can't say enough about Weaver's. I called to discuss and they were like "Do you want the replacement shipped to X or X address?" Good folks!

I purchased a 15' L3901 w/ a BH77, the owner did not have the 3 point hitch kit... (I knew this up front). Like others I priced the individual pieces from lock parts dept and stopped at $496 PER lower lift arms... Question is this - Does anyone know of a 'Wholegoods' number that works? I came...

Looking at a 2015 L3910 HST with 400 hours and a BH77 with 3 buckets total and a mech thumb. Small dent in the hood, other than that, not a blemish on the paint. Was told the BH has never been removed. Thanks in advance - Geo :)