Recent content by frysl

I recently purchased a quick hitch adapter for the back of my Kubota L3301 and overall I’m very happy with it. the issue I’ve run into is the items that have the shorter PTO shafts (chipper & tiller) don’t have enough shaft overlap to run safely. Looking around on the internet for replacement...

Made another big pile of tops a small pile of future mulch thanks to my PTO driven chipper.

I have a Woodland Mills chipper on the way and I’m wondering how to engage the PTO then dismount to feed the chipper. If I remember correctly, the seat safety switch will kill the engine once the weight comes off.

I’ve recently some logging done on my 30 acre lot. I’d like to buy a PTO driven chipper for clean up. Recommendations? It‘ll be strapped to an L3301. thanks

Thanks!

Yes, I’ll check there today. Thanks!

Hi all, I recently added a third function valve to my tractor and was wondering where I could go in town to pick up some type of protective sleeve I could slide the two new hoses into for protection. I see stuff on line, but I was hoping that maybe someone has seen what I need in a big box store...

Thanks for the info.

I do have a few EA attachments, can’t argue their quality and design.

How did you go about selling the old bucket?

I’m going into town to talk to a welder today about that. I want to get an idea of cost to remove old pin mounting tabs and weld a plate on.

I just mounted a SS Quick Attach adapter to the front end of my L3301 to use a grapple. I’d still like to be able to use a bucket for moving material, so now I need a compatible bucket. Any suggestions on what brands to look at or what to stay away from? thanks

I’ve noticed that since putting the quick hitch adapter on, the curl/dump cylinders will now retract about an inch more than previously.

Id like to adjust the travel on the hydraulic cylinders the curl/dumps the loader bucket. I would like to take just a little bit of the curl out. is that possible?

Very nice!