Recent content by flkeysff

My MX4700, I think, does not have the pressure (power) it once had. My only reference to this is I have a back hoe attached and I used to be able to lift my 600 lbs generator. I can no longer lift or even budge the generator off the ground. What might be the cause of this? I have 94 hours on...

Well it turns out that the control lever had bent under the bracket. Thanks for all your help.

Thanks I will check it out and report back

I have a question I seem to have a issue going on with my PTO, the lever used to raise my PTO has a scale 1-8 I think with 8 being fully raised. My problem occurs when I try to go to 8, it causes the hydraulics to whine and the front end loader will raise very very slow. If I lower the lever...

Thanks. I will get it. This should be a big help!

I am planning on working it, I hope it will improve. Thanks

Thanks for all the help, in regards to the dealer I have not taken it to them, however talking to them on the phone they think I have a cylinder leaking internally.

I guess what I need to know is how to test the control valve for leaks? In simple terms. Thanks

Hello, I have been trying to figure a way to check the hydraulic system on my BH92 backhoe. I would take it to kubota however it is over 120 mile one way to the dealer. My backhoe over two to three days while attached to the tractor will leak down ( the bucket and stabilizers) If I remove...