Recent content by Eikermann

Well I learned a lot from this, rebuilding diesel injection pumps is probably a little bit beyond my reach to be doing in my little shop in the backyard with no equipment lol but I reached out to Thepumpguysc and since I’m in North Carolina and he’s in South, I elected to drive it straight to...

So I just need to replace it as a whole unit because my plunger is stuck in on mine

Am I missing something on how to take the idle apparatus off or do I have to pull all that other stuff off to be able to unscrew it. I noticed my plunger that is supposed to be sticking out is stuck in

No I don’t have any special equipment, and could not find anybody local to me that rebuilds them so I was gonna give it a shot and see. But now I can’t find anything on how or where to time/clock the delivery valve holders. I did keep all the same components together and not mix up any of the...

I bought a L3130 that was not running and from my guess it probably sat for a year or two. So after all the other problems I have got figured out I got to the point where I was getting no fuel tracked that down to the injection rack being froze or seized and would not budge. So I got the...

So I believe I am kinda stuck temporarily, without being able to move the rack, I can’t even get the injection pump out

Yes, stop solenoid is functioning correctly. I took the stop solenoid off the motor and try to manually move the rack and it will not budge either direction. Sprayed some pb blaster on it and still no luck

The rack in the injection pump should slide back and forth correct?

I did see that I had a leaking crush washer on one of the injectors

Took the line off the lift pump and it had a good steady stream of fuel, then while starting tractor it pulsated

Ok I will check the flow going to the injection pump again. Has new fuel filter and filter housing is full. What’s the deal with the 2 ON’s and 1 OFF on the petcock

Trying to start a l3130 gst that has been sitting for a year or two. I seem to not be getting any or enough fuel. I tried the fountain test and saw no flow, opened the primer thumb screw and tried that also. Is there anything else I need to possibly check with the injection pump since it has...

Gauge cluster seems to have fixed my electrical issue

Please don’t tell me that, looking at the pin out for the connectors that plug into the Intel panel. The connectors are identical, but it seemed like the termination points for the wires were different so I think that’s why I was blowing the fuse