Recent content by DWSchwefel

I Will also do a better job on trying to locate the timing marks, now that I know where to look and do a start of delivery procedure.

It was mounted and in place. The pump was removed and remounted. I most likely didn’t keep track of the shims at the time. I’ll do a compression check when I change the injectors. Thanks.

The IDI engine was removed from a refer unit and wasn’t run for close to five years. I ran it for only about 20 seconds before removing/purchasing it.

injection pump was from and with the idi engine.

I’m going to change the injectors first. I don’t have gray or white exhaust (excess/unburied fuel) which would suggest late injection. Also, I can’t speak to loss of power at this point. I’ll report back once the injectors are changed. This engine is a idi engine no longer direct injection. Thnx.

Yes. I did a bunch of reading last night, Found some helpful info.

I have an L4350 tractor. It has a V2203 engine that I transplanted into the tractor. Initial start up went without a hitch. Idles and accelerates fine. After a few seconds of run time it develops a fuel knock. Injection pump shims are most likely not correct, there was a lot of time between...

The original inj cam lobes are the same as the replacement inj cam lobes.

I took a few more pics, will post. I took the gear cover off today. The marks on the gears were not lined up. I wanted to turn the engine to get them to line up, I quickly discovered that I had a problem. I couldn't rotate 360 degrees. I figured that I may have moisture or some water...

Thanks for your help again. I’ll take a few more pictures and compare the inj cams. I have a few electric fuel pumps laying around, but I’ll look at drilling the holes, I can’t use the Kubota fuel pump anywhere else. Question: the front crank nut.... I have a deep 1 13/16” socket for it. I...

The injection lines were off because I was getting ready to remove the intake manifold. I can post a picture of the head if you'd like. I will check the crankshafts/flywheel and oil seals, thanks for the info.

I got a good look at the IDI block. One of the above pictures shows the mechanical fuel pump, this is where the hydraulic pump will attach.

pictures posted......

Gentlemen, I am also looking for a set of tires, ag style. If you know of any leads, let me know. I have a few bad hydraulic hoses. I will make them up, I have my own crimp machine......any thoughts on a good source for fittings? thanks. DaveS

c