Recent content by docwatson

I am not familiar with this model. Is it possible to install either filter backwards? Most have arrows indicating the direction of flow. If it is a spin-on filter, try backing it off until it leaks a bit to bleed any air out of it, then snug it down.

Yes, remove all the injectors , screw the compression gauge into the hole and spin the motor. Do each cylinder. Write down the reading for each cylinder. Look up the acceptable pressure reading.

I have a good Kubota three cylinder engine. It is a model 1403. I want to put it in a Kubota L245DT tractor. I see the front differential bolts directly to the engine block unlike the tractor I have it in now, which uses some metal plates along the side of the engine block to mount the front...

I am installing a Kubota V1903 engine in an older Kioti LB 2204 Kioti tractor.I have completed the mechanical part of the installation (pretty easy, the Kioti is a clone). Because the 1903 is a much later engine, the wiring is different, so I need a wiring diagram from a 3-cylinder Kubota...