Deeds86's latest activity
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.I do not have a fel range on my tach only the 540 pto range, from what I've gathered 16 to 1800 should be the sweet spot possibly up to... -
Deeds86 reacted to Bearcatrp's post in the thread New member, and new owner of a L2502HST with
Like.
Welcome to the forum and congrats on the new tractor. Am north of you, up by St. Cloud. I start mine on low throttle , then bump it up a... -
Deeds86 reacted to Russell King's post in the thread New member, and new owner of a L2502HST with Like.
Keep the loader close to the ground while bucket is full. Your center of gravity is probably higher than your previous equipment so...
-
Ditto what MapleLeaf and others have said. My Kubotas were pre-emission models but I treated them with all due respect anyways. Almost...
-
Deeds86 reacted to GrumpyFarmer's post in the thread New member, and new owner of a L2502HST with Like.
Welcome and good luck with new machine. I really like the standard Ls…good choice. Only comments I have is related to break in. I am...
-
Deeds86 reacted to Hugo Habicht's post in the thread New member, and new owner of a L2502HST with Haha.
That is the problem, it will be hard to use it because it is so new and shiny. I tell you what: you put this tractor into a glass...
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.Im pretty sure I seen that video, if its the one where he bailed right before it flipped over? If its in 4 wheel I'd have to assume...
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.Thank you! Absolutely safety first! I did get beet juice in the rear so ballast is on the radar! I will pay close attention to the...
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.Thank you for taking the time to write this out and answer in detail! It is absolutely helpful! I worked long enough to afford it and...
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.Thank you! OK so not running wot for breaking it in Shouldn't be an issue at all at least! As of right now I've got no pto attachmets...
-
Welcome aboard and very nice tractor! I consider max RPM is what happens when I peg the throttle lever. I rarely run much over 2000...
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.Haha, wouldn't that be a rough life!!!
-
That is one heck of a shed! 😂 Seriously though, great tractor and welcome to the orange club.
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.I appreciate your words of wisdom there!!! Luckily I've got a little experience on skid loaders and loaders! I'll be watching for it...
-
Deeds86 replied to the thread New member, and new owner of a L2502HST.
-
