Recent content by DCM303

I am so sorry, I should have posted, it has been sold. My apologies.

You are correct, I took it off an L4060.

SOLD.

Back on Jan. 1st. I posted about some mods I did to include running some 4AWG cables to the rear of my L4060LE and adding a couple power distribution blocks (positive and negative). These fed a fuse block that I wired to a USB power port and a 12 vdc power plug and a couple Artillian lights to...

That is why, I wanted the breaker to be below the max capacity. It'll be a couple week but I'll get some photos.

I ran two 4 gauge wires from the battery to the back of my L4060LE, most in split loom to power a winch. The wires feed into two (positive & negative) distribution blocks. I installed a 60 amp breaker in the positive cable close to the battery. From the distribution blocks I ran 12 gauge wire...

I used ten bags of #80 quickcrete. Works great, made a BIG difference how the tractor performed. It needs more concrete and a slot cut for the upper link to travel in. That'll happen when at the farm next. I did weld some rebar to the upper link receiver, they make a triangle and go about 16"...

I'm new at this but have done a lot of research on counterweights, I have to say this one is by far my favorite. I have a 55 gallon barrel filled with 800 pounds of concrete. It works fine but this one is very nice.

I've used a couple gallons of the Herculiner from Lowes on other projects and it's all in the prep work. Getting the metal as clean as possible after scuffing it seems to make the difference.