Recent content by daredevil1166

I think that's just how things are these days. Way OT but in my opinion it has everything to do with money. For many reasons working a parts counter(or really most dealer jobs except sales) doesn't pay diddly so it's not a viable career option. From what I've seen the most knowledgeable...

Apparently this is common. I replied to another thread with the same issue but didn't see yours. I'll just copy/paste what I had there, yours should be the same......... Kubota part number for your connector should be HHT1K-91103. Should be readily available for any dealer to order from the...

That extra block is generally known as a third function. It is just looped into the system in series and isn't likely contributing to your issue. It could be before or after the loader valve in the circuit depending on how it was built. You are half correct. There are 2 pressure lines but...

Kubota part number for your connector should be HHT1K-91103. Should be readily available for any dealer to order from the mother ship. They should also be able to look up a photo of the part so you can verify. It sure looks the same to me.

There is a gear reduction case behind the engine that is filled with hydraulic fluid. Your leak is likely the output shaft seal of that gear case. The tractor has to be at least partially "split" at that point and the 2 halves rolled apart to remove the driveshaft to replace that seal...

Can you post a picture of the control lever/valve? A lot of aftermarket loaders were installed on b7100's so it would be nice to see exactly what you have. That being said it is common for the lever, yoke, and pins on the valve handle to wear and do exactly what you describe. You think you...

This is normal. The G series has orifices that bypass fluid allowing some movement without the tow valve. I don't know for sure but I believe the noise is gear chatter as the HST bypasses because they have a somewhat unique gear case between the engine and HST.

Right! I just saw that yesterday. I bought the pump months ago. I don't mind the money actually. This tractor has been a fun project and a cool learning experience. I don't get to do anything interesting with tractors this age at work. The threshold for paying labor rates is so low when...

Good catch. I didn't find the relief valve in the outlet block until after I did all this work. I only saw the 3pt relief referenced in the service manual. It was bugging me that they both quit @ 1900 and the outlet block has a return hose to the suction side of the pump. So I looked in the...

I wanted to share some info here because this forum is where I got the idea and I may be able to save someone the time and money of doing what I did. I tried to upgrade the hydraulic pump on my B6200 with the Whitehouse Products GP0120 pump. It mounted up just fine but one of the things I...