Recent content by country53

I use a 1" drive breaker and hook a chain to it and hook the chain to another tractor and take off I figure either socket or bar will break or the nut will break loose so far I've did it around 50 times nut has always broke loose, I made a fixture to go on breaker bar to hook chain. I heat the...

I was having that problem, I found the water separator fittings to be plugged inside of manifold cleaned but then the fittings would leak air bought a new one everything is ok now

it is easy Remove lines and 2 10mm hex nuts(6mm studs) and remove

My M8200 was doing same thing I found water separator unit had a blockage in it plus fitting was leaking allowing air to get in fuel system. Fuel pump was also weak maybe because of not being able to get fuel I replaced water separator, lift pump and fuel filter and it worked fine

I had a similar problem with M8200 water separator was plugged where fitting for supply goes in and fitting was loose stuck it under water and pressurized with mouth and saw air bubbles coming out around fitting and then I found after it sat a while it would have air in system, I checked oil...

My new after market fuel pump was bad. I changed out water separator, fuel filter and fuel pump with all parts from Flemingsburg Kubota dealer and machine worked fine, I also insured all lines going to tank were open. Thanks for all help!!

Yes checked and it was blocked I removed the problem and it would still suck the fuel out of the bowl and leave a open place in the separator, I back blew the line that's when I noticed the tank would pressurize the only way to relive the pressure was to take fuel cap off , so I removed the fuel...

It is an open station tractor, the vent isn't the problem , tractor still lacks fuel sporadically, still working on it though, hope I find the problem soon

thanks

How is an M8200 fuel tank vented. I was back blowing a fuel line checking for blockage and it pressurized the tank. I took the line off next to gas cap and when I blew in it air came out of fitting I took it off of. Does anyone know where the tank vent is.