Recent content by Chucks b

  1. C

    M5700HDC SEAT

    Any recommendations on replacing or recovering the seat cushion? Thanks Chuck
  2. C

    M5700 4-wheel drive problem

    Just checked each side , one at a time as your recommend They both roll free and no unusual noise or play on either side!! Thank you Chuck
  3. C

    M5700 4-wheel drive problem

    No new tires ! Thank you! Chuck
  4. C

    M5700 4-wheel drive problem

    When I serviced the frontend yesterday I rolled both tires ,seemed to roll fine no resistance or any strange noise ! But that was with both fronts off the ground same time . would 1 wheel at a time as you suggested be different ? Thank you Chuck
  5. C

    M5700 4-wheel drive problem

    I checked ,Both rear tires are the same PSI !! Thank you Chuck
  6. C

    M5700 4-wheel drive problem

    M5700 4-wheel drive Hyd shuttle w/cab When I Engauge the 4-wheel drive There is no slippage in the drivetrain when I shift to neutral ,the tractor feels like I am pressing on the brakes !! stops pretty quick, will not drift at all ??? It's fine in2-WD No unusual noises in the drive train My...
  7. C

    Front fenders M5700 HDC

    Need help/ advice !! Want to add front fenders , does any one know where to buy ?? Been searching the net & have got no where Thanks Chuck
  8. C

    M5700HDC clutch housing

    Thank you for the info!! Great to have this forum for help !!!having a local Kubota tech check it on Saturday , I'll get his input and decide what I'm going to do !! Again thanks to everyone who responded Chuck
  9. C

    M5700HDC clutch housing

    Will it hurt anything to run the tractor , if I keep the fluid levels full ???
  10. C

    M5700HDC clutch housing

    Drained the clutch housing& about 2 quarts of really brown oil& a some water came out ,,the next morning I noticed there was oil on the shop floor , the plug was not tight enough!! Should there be oil in the housing ??
  11. C

    m5700/LA1002 loader 3rd vALVE

    Tried hooking the plow lines together,that didn't work ,then I shut the tractor off worked the joy stick to relive pressure on the tractor ,then turned the key on and hit the toggle switch back and fourth and still couldn't get the plow lines hooked ?...
  12. C

    m5700/LA1002 loader 3rd vALVE

    did not know there were 2 styls of flat face couplers thanks for that!! I was hoping to find a way other then cracking the line to release the pressure , I will check with my local hyd shop on the style of couplers he sold me Thanks for the feed back Chuck
  13. C

    m5700/LA1002 loader 3rd vALVE

    NEED HELP!!! Just installed eclectic over Hyd 3rd valve to my FEL/ how do I release pressure to hook up couplers on the 3rd valve ,having a lot of trouble getting them hooked back up because of pressure still in the lines !! using it for a power angle snow plow also using flat face couplers...
See more
Top Bottom