Recent content by ChuchVT

I know that. What I'm saying is when the 3 point hitch is fully raised the mowing deck hasn't raised enough to allow the deck height knob to rotate past the 4 setting. If I remove the drive over deck sub-frame and then raise the 3 point hitch I can rotate the knob completely.

I recently purchased a BX2370 with a 60" drive over deck. With the mowing sub-frame attached to the tractor I am unable to rotate the deck height knob to the Top position and I can't rotate the knob clockwise to decrease deck height. If I remove the mowing sub-frame I am able to rotate the...

I put the subframe on last night and it appears I do need the longer shaft. Thanks for the help!

I have a BX 1870-1 with a BX2751 quick hitch which I use with a snowblower and 60" plow. I just bought a 2370 and it appears I need to buy a longer PTO shaft. Can I just buy part number 70060-02338 and call it a day or do I need to replace the output shaft PN 70001-00772...

That's what I put on this morning. Great minds!

And we have the winner! That's exactly what happened.

I went out to plow this morning and I made two passes down my driveway and when I tried to back up it was very slow. It was also slower than normal going forward. When I got back to the top of the driveway I couldn't go in reverse at all and I could hardly move forward. I moved the gear...

Thank you!

Is the area circled in red what I should be spraying with WD 40?

I haven't used the PTO lever since I finished mowing in September. I always store the tractor in the garage. Do I need to remove the tire to get to where the shaft goes into the housing?

I can't seem to move the lever that engages the PTO on my BX1870. The lever that selects Front/Mid/Front and Rear works smoothly. I can't see anything that's blocking the lever from moving.

There's something to be said for reading the post in it's entirety...

They drilled the old pin out. If you look at the photos in this thread you will see the shaft and auger holes are offset and the pin could NOT be tapped out.

I ended up bringing it to my dealer and they ended up drilling it out. Sooo, I've invested in some metal drill bits but I think I will try the hammer idea if it happens again.

Thank you all for your help.