Recent content by chromeaholic95

I just got back into the shop (after Christmas and New years) and disassembled the rotary valve again and cleaned both sides. tested with air, and it shifts like it should. reinstalled in 2nd gear and refilled the case. shifts into 2nd and 6th, but nothing else. how far does the pressure...

I checked everything in the GST valve and found that if I put the transmission in 1st gear when installing the GST valve, it will move and has pilot pressure like it should. it also shifts into high range 5. Problem is it will not shift into anything but 1st and 5th. When I first started to...

I did check the orientation of the rotary valve and it is in the correct spot with the detents facing each other in neutral.

That's what I was hoping for on the clutch pack. I noticed that all of the accumulators and modulators still had contaminated oil in there. Ive taken most of the GST valve apart and cleaned it. Except for the clutch valve, and low pass valve. that will be either today or tomorrow.

Hello all. I'm new to the Orange tractor talks, but am not new to the workings of the L35 kubota GST. I brought an L-35 into my shop for repair (would not move) . Found the Hydraulic clutch was broken, and metal and material were all over inside the case. Split tractor and replaced the...