Recent content by chrissuter

Well, I have the 2501, I was discussing regarding the auger, I have the Top/Tilt in the rear, I have top float, it is using the two levers to the right of the drivers seat and I believe factory valves. The dealer says the third function and top/tilt can exist of the output right under the...

I have a L2501. I was thinking of mounting a hydraulic auger on the skid steer mount on the loader. There are several videos online that say it is fairly usable at the relatively low flow from the pump. I only need a 9" auger and don't particularly care how fast it is, although really slow...

Thanks for the advice, I removed the PTO bracket and found one of the two micro switches had a slightly smaller travel than the other one. I bent the tab out slightly and now it all appears good. Thanks again.

I have a relatively new L2501 (just at 100hr). I just developed a problem with the PTO safety switch. In order to atart the tractor, I have to pull the PTO engage lever (yellow) all the way to the rear. It is not fully engaging the safety switch when it is seated. I do not see an easy...

I have a L525 loader on my tractor. I want to switch it to skid steer quick connect. I have a couple of questions: 1. Should i get the L2230A from Kubota or but an aftermarket adapter 2. Should I cut and weld my existing bucket or buy a bucket set up for this? Any advice would be...