Recent content by CEdwards

Yes you were very helpful with my last issues thanks again. So it turns out when I went to take the quick connect and the snowblower off so I could manually push my tractor into the garage I found out that the 11.5" output shaft(which was the correct length) actually vibrated loose somehow. I...

So I was using my BX2750D with the 2751 quick connect when I heard an awful rattling noise coming from the front of the tractor. Next thing I know the PTO shaft came flying off the output shaft on the 2751 and was flying around under the tractor. I immediately turned the PTO off. I looked under...

Well just as my luck is i think I have caused myself a very expensive fix in trying to "tap" out the shaft. There are two set screws on each bearing which I removed. The shaft wouldn't budge with a tap so i stood it up on end and tried a couple very short swings with a 4 lb sledge. the shaft...

Ok that makes sense based on the smooth portion of the output shaft not being long enough for the bearing to be on that side. So it looks like I will just undo the two bolts, flip the bearing to the inside and make sure I have the proper length. Thanks again for your help ill let you know if it...

So there are 4 main screws two per section that look like 9/16 or something like that. These aren't the set screws your talking about are they? Is there any kind of seal that I need to worry about or is it just as simple as you explained with the loosen/tap out/tap in. I am decent mechanically...

Your bang on there squidget. I have an output shaft length installed in the BX2751 of 14 7/8" and the mid PTO shaft is too long because of that. What are my options here? Do I just change the driveline kit to the 11 1/2" shaft? is this easily done or do i need a whole new bx2751 with the proper...

Good morning Gents I recently read that the BX 2751 and 2752 are required in order to mount the 2750D on my BX1850. I have attached a picture of my mounting bracket on the front and it almost looks like it will work with the two pins on the BX2751 quick hitch. Im looking to find out if I will...

Thanks so much for the info I am quite new when it comes to owning a diesel tractor. I would like to pick your brain again for another issue. I have the quick hitch bracket(2751) with the snowblower for the 2750D. I however do not have the 2752 mid PTO bracket. The bracket on the front of my...

Hey gents I just bought a used BX2750D which was hard to come By and I noticed that the outer two edges(that feed snow to the auger, or the front two corners)are bent inwards slightly which isn’t normal. The cutting edge is also bent back on the right side. I have two questions. Is it easy to...